1. DL manuals
  2. EcoWater
  3. Water Dispenser
  4. ETF2100PF10
  5. Owner's Manual

EcoWater ETF2100PF10 Owner's Manual

Manual is about: ETF2100 PF Series

Summary of ETF2100PF10

  • Page 1

    1 printed in u.S.A. Part no. 7217933 (02/2000) ecowater systems p.O. Box 64420 st.Paul mn 55164 - 9888 owners manual how to maintain and operate your ecowater multi--purpose filter series etf2100 pf.

  • Page 2

    Unpacking, table of contents ecowater s y s t e m s 3 2 unpacking ecowater multi--purpose filters are shipped from the factory in 1 master carton consisting of ... ...Mineral tank and valve assembly ...Controller cover and timer assembly ...Skin--pack of small parts (includes this manual) note: filt...

  • Page 3

    Warranty, safety guides ecowater s y s t e m s 3 3 ecowater systems, inc. Advantage warranty series etf 2100 water system congratulations! You have just purchased the highest quality water conditioning product on the market. To register your warranty, complete the enclosed warranty registration card...

  • Page 4

    14” 14” a b specifiecations / dimensions ecowater s y s t e m s 3 4 etf2100pf10 10”dia x 47” resin tank etf2100pf12 12”dia x 54” resin tank filter type, mineral ¡ sediment removal filter aggregate limits factory recommendation based on water analysis acid neutralizer neutralite water supply ph limit...

  • Page 5

    Assembly instructions ecowater s y s t e m s 3 5 fill the mineral tank 1. Remove the tank clamps, figure 1, valve assem- bly, o--ring seals (3), and the top distributor. 2. Using a funnel, add the specified amount of filter sand, then the mineral. Note: the filter is factory filled with the correct ...

  • Page 6

    Planning installation ecowater s y s t e m s 3 6 figure 2 -- typical installation drawings inlet -- outlet options 1”copper tube (2 supplied) 1”x 1”sweat 1”x 3/4”sweat 1”sweat x 1” or 3/4”pipe thread floor drain floor drain note: faceplate and support not shown for clarity of drawing. Tie or wire va...

  • Page 7

    Planning installation ecowater s y s t e m s 3 7 tools you may need d common screwdriver d pliers d cross--point screwdriver d tape measure soldered copper threaded cpvc plastic d tubing cutter d hacksaw or pipe cutter d hacksaw d propane torch d threading tool d adjustable wrench d lead--free solde...

  • Page 8

    Installation ecowater s y s t e m s 3 8 1. Install inlet and outlet fittings note: all fittings are on the small parts skin pack. A. Insert the turbine support, into the valve outlet port, up to the shoulder. Note: if installing the ecowater bypass valve, see separate instructions included with it. ...

  • Page 9

    Installation ecowater s y s t e m s 9 3 6. Cold water pipe grounding the house cold water pipe (metal only) is often used as a ground for the house electrical system. The 3--valve bypass type if installation, shown in fig- ure 2, will maintain ground continuity. If you use the plastic bypass valve a...

  • Page 10

    Installation ecowater s y s t e m s 3 10 note: in addition to a floor drain, you can use a laundry tub or stand pipe as a good drain point for this hose. Avoid long drain hose runs, or elevating the hose. 9. Pressure testing for leaks to prevent excessive air pressure in the filter and plumbing syst...

  • Page 11

    Programming face plate timer ecowater s y s t e m s 3 11 figure 10 display display display current time and day keypad recharge time keypad recharge days keypad set keypad vacation / recharge now keypad 1. When the transformer is plugged into the electrical outlet, 12:00 am, sunday begins to flash i...

  • Page 12

    Programming face plate timer ecowater s y s t e m s 3 12 4. Press the recharge days keypad again to display a flashing monday and on (factory set re- charge). As you did in step 3, use the set keypad to change the display from on to off, or from off to on, as desired. 5. Press recharge days keypad t...

  • Page 13

    Programming face plate timer ecowater s y s t e m s 13 information for qualified technicians only recharge cycle time adjustments: factory set default cycle times are: backwash ...25 minutes, and fast rinse ...5 minutes. Do the following to check for correct cycle times. Note: removing from electric...

  • Page 14

    Filter operation ecowater s y s t e m s 3 14 general information ...Sediment filters -- a sediment filter removes, sand, clay, silt, or fine organic matter from water. You can see sediment in water by holding a sample, in a clear glass, up to a light. The particles are either suspended or settled to...

  • Page 15

    Filter operation ecowater s y s t e m s 3 15 water flow paths figure 11 service cycle figure 12 backwash cycle.

  • Page 16

    Filter operation ecowater s y s t e m s 16 figure 13 fast rinse cycle.

  • Page 17

    Service information ecowater s y s t e m s 17 neutralizing filter -- checking the min- eral level in the tank: as explained on page 14, the mineral dissolves in the water to neutralize the acid. How fast is dissolves depends on how much water you household uses and the ph of the water. Every few mon...

  • Page 18

    Pm mo we th fr sa rchg . . Am tu su service information ecowater s y s t e m s 18 troubleshooting always make these initial checks first 1. Does the time display show the correct time of day? ...If display is blank, check power source to the filter. ...If time is flashing, power was off for over two...

  • Page 19

    Service information ecowater s y s t e m s 3 19 other service unfiltered water bypass (unfiltered water “bleeds”into filtered water supply. 1. Defective inlet disc, seal or wave washer (see pages 30 and 31). 2. Missing or defective o--ring(s) at resin tank to valve connection (see key no. 11, page 2...

  • Page 20

    Repair parts ecowater s y s t e m s 3 20 18 20 19 4 1 2 3 9 8 10 11 12 13 14 15 16 17 6 7 5.

  • Page 21

    Repair parts ecowater s y s t e m s 21 key no. Part no. Part description 1 7095373 transformer, 24v -- 10va 2 7132840 power cable 3 7130767 wire harness 4 7218670 top cover 5 7218701 rep’l pwa 6 7210517 face plate (order following decal) -- 7214197 decal 7 7211173 face plate support 8 7176292 clamp ...

  • Page 22

    Repair parts ecowater s y s t e m s 22 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 25 24 28 29 30 31 32 33 22 cross--section view seal wear--strip flow plug assembly assembled view 27 26 36 35 34.

  • Page 23

    Repair parts ecowater s y s t e m s 23 key no. Part- number description of part 1 7131755 screw, #6-20 x 7/8 (2 req.) 2 7218793 motor (incl. 2 ea. Of key no. 1) 3 7218816 motor plate 4 0900857 screw, #6-20 x 3/8 (3 req.) 5 7171250 bearing 6 7219545 cam and gear 7 7169180 clip (drain) 8 7172793 drain...

  • Page 24

    Printed in u.S.A. Part no. 7217933 (02/2000) ecowater systems p.O. Box 64420 st.Paul mn 55164 - 9888 (651) 739---5330