Ecox E RG51B30/(C)E Owner's Manual - page 10
10
REMOTE CONTROL
PORTABLE AIR CONDITIONER
EPOR
TIMER OPERATION
Press the TIMER ON button to set the auto-on time of
the unit. And press the TIMER OFF button to set the
auto-off time of the unit.
To set the Auto-on time.
Press the TIMER ON button. The remote controller
shows TIMER ON, the last Auto-on setting time and
the signal "h" will be shown on the LCD display area.
Now it is ready to reset the Auto-on time to START the
operation.
Push the TIMER ON button again to set desired Auto-
on time. Each time you press the button, the time
increases in 30 minutes increments, up to 10 hours,
then at 1 hour increments up to 24 hours.
After setting the TIMER ON, there will be a onehalf
second delay before the remote control transmits
the signal to the air conditioner. Then, after
approximately another 2 seconds, the signal "h" will
disappear and the set temperature will re-appear on
the LCD display.
To set the Auto-off time.
Press the TIMER OFF button. The remote control
shows TIMER OFF, the last Auto-off setting time and
the signal "h" will be shown on the LCD display area.
Now it is ready to reset the Auto-off time to START the
operation.
Push the TIMER OFF button again to set desired Auto-
off time. Each time you press the button, the time
increases in 30 minutes increments, up to 10 hours,
then at 1 hour increments up to 24 hours.
After setting the TIMER OFF, there will be a one and
a half second delay before the remote controller
transmits the signal to the air conditioner. Then, after
approximately another 2 seconds, the signal "h" will
disappear and the set temperature will reappear on
the LCD display.
1
1
2
2
3
3
1
2
TEMP
AUTO
COOL
DRY
HEAT
FAN
HIGH
MED
LOW
MODE
FAN SPEED
SWING
TIMER ON
ECONOMY
ON/OFF
TIMER OFF
RESET LOCK
SET TEMPERATURE( C)
LED
DISPLAY
TIMER ON