Ecox EAEM series Owner's Manual - page 6

6

EAEM

SPLIT-TYPE ROOM AIR CONDITIONER

For a detailed explanation of each function, refer to the 

Remote Control Manual.

OTHER FEATURES

SETTING ANGLE OF AIR FLOW

Auto-Restart

If the unit loses power, it will automatically restart with the prior 

settings once power has been restored.

Anti-mildew (some units)

When turning off the unit from COOL, AUTO (COOL), or DRY 

modes, the air conditioner will continue operate at very low 

power to dry up condensed water and prevent mildew growth.

Wi-Fi Control (some units)

Wi-Fi control allows you to control your air conditioner using 

your mobile phone and a Wi-Fi connection.

Louver Angle Memory (some units)

When turning on your unit, the louver will automatically resume 

its former angle.

Refrigerant Leakage Detection (some units)

The indoor unit will automatically display “EC” when it detects 

refrigerant leakage.

For a detailed explanation of your unit’s advanced 

functionality (such as TURBO mode and its self-cleaning 

functions), refer to the Remote Control Manual.

Illustrations in this manual are for explanatory purposes. The 

actual shape of your indoor unit may be slightly different. The 

actual shape shall prevail.

On louver angles

When using COOL or DRY mode, do not set louver at too vertical an 

angle for long periods of time. This can cause water to condense 

on the louver blade, which will drop on your floor or furnishings. 

(See Fig. 2.2).

When using COOL or HEAT mode, setting the louver at too vertical 

an angle can reduce the performance of the unit due to restricted 

air flow.

Do not move louver by hand. This will cause the louver to become 

out of sync. If this occurs, turn off the unit and unplug it for a few 

seconds, then restart the unit. This will reset the louver.

Do not put your fingers in or near the blower and suction side of the 

unit. The high-speed fan inside the unit may cause injury.

Setting vertical angle of air flow

While the unit is on, use the SWING/DIRECT button to set the 

direction (vertical angle) of airflow.

Press the SWING/DIRECT button once to activate the louver. 

Each time you press the button, it will adjust the louver by 6°.

Press the button until the direction you prefer is reached.

To make the louver swing up and down continuously, press and 

hold the SWING/DIRECT button for 3 seconds. Press it again to 

stop the automatic function.

Setting horizontal angle of air flow

The horizontal angle of the airflow must be set manually. Grip 

the deflector rod (See Fig.2.3) and manually adjust it to your 

preferred direction. For some units, the horizontal angle of the 

airflow can be set by remote control. please refer to the Remote 

Control Manual.

NOTE

NOTE

1

2

CAUTION