Summary of GDI-EXEJ300
Page 1
Models: gdi-exej300 / 301 user guide eco jam.
Page 2: Important:
On/off press the standby power button once to power on/off. Important: standby power function will not operate when the master power is set off. Master power switch under the cap on the back panel must be set on for standby & your ecojam to operate. Bluetooth when turned on, the ecojam will power on...
Page 3: Charge Your Ecojam
Set up recommendations 1-2-3 charge your ecojam before you power on your ecojam for the first time , for best performance, connect the usb micro port with a usb cable to a power source and fully charge your ecojam. Note: charge the unit until all 5 led battery level indicators are solid blue, indica...
Page 4: Connecting With Bluetooth:
Bluetooth pairing & your audio connecting with bluetooth: connect to your smart device & play audio when your ecojam is turned on, the blue led light on the top panel will flash rapidly indicating the unit is ready to pair. Turn on bluetooth on your bluetooth device (smart device) and set the device...
Page 5: Pairing Mode:
Once connected, select and play your desired audio. Pairing mode: if the led is not flashing or if you wish to place your ecojam in pairing mode, press and release the bluetooth button . Your ecojam shall announce “pairing ready” when ready to pair to a new device. Note: your ecojam shall sync & wir...
Page 6: Not
Important: maintaining waterproofness if the cap on the back panel is not properly closed, the unit is not watertight. To ensure the unit is watertight & waterproof, always close the cap properly . Turn the cap to the right so the cap’s arrow point lines up with the locked symbol along the back edge...
Page 7: Note:
Audio aux-in connect an audio device using the 3.5mm cable connection as an alternative to a bluetooth connection to your ecojam. Note: volume level must be controlled from the audio device when connected to the aux-in connection. Input connect the usb cable to the usb micro input to charge your eco...
Page 8: Unit Weight
Unit weight 25.1 ounces s/n ratio 88db +/- 3db output power rms 20w (10 watt x2 speakers/ 4 ohms) specifications output connect to the usb output (5v, 1a) port to charge your personal device. Use the usb cable included with your personal device. Note: charging rates are similar to the charging rate ...
Page 9: For Charging
User guide models: gdi-exej300 / 301 eco jam for charging ac (5v, 1a) usb wall outlet power adapter ac (5v, 1a) usb car power adapter for mounting suction cup mount (¼” mount) handlebar mount adapter (¼” mount) carabiner usb cable optional accessories fcc compliance statement & warning: this device ...
Page 10
Can be submerged in up to 3 feet of water for 30 minutes without any damage. However, the speaker is not intended for constant underwater use. Always make sure the cap(s) / covers(s) are clean, free from sand or debris, and correctly fitted. The speaker will only meet ip67 ratings if all rubber seal...
Page 11
Please exercise care and good judgment when using your ecoxgear speaker. Audio levels should be appropriate to your environment, comply with all local regulations, and always ensure that you can hear and be aware of any potential hazards around you. You should always 1) use the ecoxgear speaker in a...
Page 12
3) dry unit completely before opening the cap. Do not open the cap if wet or in a wet environment. 4) do not apply excessive force to any surfaces of the unit when wet or in a wet environment. 5) do not use or store the unit in places with high temperature. 6) avoid prolonged exposure to ultraviolet...