Summary of GDI-EXJMP1500
Page 1
Models: gdi-exjmp1500...1520 user guide eco jump.
Page 2
2 3 fcc statement: this device complies with part 15 of the fcc rules. Operation is subject to the following two conditions: 1) this device may not cause harmful interference, and 2) this device must accept any interference received, including interference that may cause undesired operation. Warning...
Page 3
4 5 safety: this product has a limited life span of use and should be replaced when it shows obvious signs of wear. Do not modify or remove any original component parts of the device. Doing so could cause damage to the unit allowing water to ingress. A unit with water ingress should not be charged d...
Page 4: Control Buttons & Operations
06 07 control buttons & operations on/off unit will arrive powered off. Press and hold the power button for approximately 2 seconds to power on. When on, short press to put in standby mode. Short press again to turn unit on. Keep in standby mode when unit is not in use to enable battery notification...
Page 5: Jump Starting Your Vehicle
08 09 jump starting your vehicle caution: do not attempt to jump start if unit and/or connections are wet or damp. To access the jump start connection on the side of your ecojump, pull tab on the rubber cap that reads, "engine start." once the rubber cap is removed, the jump start connection will be...
Page 6: Manual Override
10 11 the ecojump is designed to jump start 12v lead-acid batteries with voltage readings down to 3.2v. If your vehicle battery is below 3.2v, the ready to jump led will be off (even after connecting correctly to the pos and neg battery terminals). This is an indication that the ecojump cannot detec...
Page 7: Usb Charging Connections
12 13 before using the manual override feature, make sure the jump start cable plug is connected to the ecojump and the jump start clamps are connected to the correct polarity battery terminals. To use the manual override feature, press and hold the override button . The ready to jump led and overri...
Page 8: Ble and Smartphone App
14 15 ble and smartphone app extreme temperature mode bluetooth low energy while your ecojump is on or in standby mode, it will communicate its battery level and temperature via bluetooth low energy (ble) to nearby smartphones. Download the ecojump app to your smartphone. The app is available on the...
Page 9: Specifications
16 17 unit weight 27.3 ounces jump start output power 600a peak power source 11.1v, 5000mah, 55.5wh lithium battery usb input 5v, 2a usb output 5v, 2.1a / 5v, 2.1a bluetooth low energy (ble) communicates the battery level and temperature to your smartphone led flashlight 200 lumens unit dimensions 8...
Page 10
18 limited manufacturer’s warranty: the ecojump is covered by a 3 year limited warranty that covers defects in workmanship and / or materials for a period of 3 years from original purchase date. This warranty does not apply to any products which have been abused, neglected, modified or used for a pu...