Ecozone Super ActivO User Manual - page 18

P a g e

 | 

18 

18

d. Gently pull out the Singlet in parallel motion from its supporting screws. 

Be careful not to touch 

                 or scratch the glass tubes. 

e. Clean the Singlet core under warm tap water, especially the gaps between the tubes. 

                You may use a soft brush to remove any accumulated dirt.  

Use care not to wet the electrical connector. 

     f.  Repeat the same procedure above for the second Singlet core on the left side of Fig D. 

     g.  Drying may be done using a soft towel or in air.   

     h.    Re-mount  each  Singlet  core  on  its  leading  screws  –  slide  in  parallel.   

Be  sure  to  re-insert  Singlets  so 

that the 3 tubes are on the side facing you as shown in Figure C 

     i.  Re-attach the electrical connector to each Singlet core

Be sure the connectors are dry. 

     j.   Re-screw the two nuts onto each Singlet supporting screw..

Step 3     Close black front grill panel  

a.  Replace the front grill making sure the dust filter is on the inside of the unit. 

Make sure the earth cable to the grill is completely inside the unit. 

b.  Re-screw the 6 screws around the frame of the panel.