ECR International C1318-601VAR Use And Care Manual - Service Calls
SERVICE CALLS
Before you call for service, check the Troubleshooting Guide first in Table 1.
Problem
Possible Cause
Solution
1. Power off
2. Incorrect thermostat settings
3. Open circuit breaker or blown fuses
1. Make sure main switch is ON
2. Set thermostat to proper setting
3. Reset or replace
Table 1: Troubleshooting Guide
1. Dirty filters
2. Indoor air blockage
3. Blocked outdoor coil
1. Clean and replace
2. Check supply registers & return
grills for blockage
3. Clear away leaves or other debris
1. Blocked condensate drain
and “P” trap
1. Remove blockage
After reviewing the troubleshooting guide, turn thermostat to “OFF” for 10 seconds
and restart the system. Wait for 5 minutes. Call for service if system does not start.
Periodic inspections and services by your professional serviceman will help to keep
your system operating at peak performance reducing operating costs and reducing
the chance of major repairs.
If a repair is needed, the serviceman will want to know if your unit is still under
Warranty. Take a few minutes to record the following information here:
Outdoor Model and Serial Number
Indoor Model and Serial Number
Thermostat Model Number
Date Installed
Installing Dealer
Service Phone
No cooling
Insufficient
cooling
Water on
floor or in
furnace