Ecreso Helios FM 20/100 W User Manual - page 16
Helios FM 20/100 W, user manual– 12/2011
4.2.
Setting the transmitter
1. On the PC, start the control software. This is a set-up tool that will allow you to quickly set and test your
transmitter. All settings and measurements are also available on the front panel screen and with serial
commands.
2. Select the port connected to the Helios and its speed.
3. The “Get all” button allows you to retrieve current values (9600, 8, N, 1 for the front panel connector).
4. Set the power (in W), the frequency (in MHz) and enable the RF.
5. Set other parameters as desired. Value formats for all parameters are available in the list of serial
commands (see manual).
6. To send a parameter value to the transmitter, click the login button; no password is set in factory. Click
then
to the right of the text zone or click “Send all” to send all set values.
4.6
4.3
4.2.4
Page 16
Head Office : Parc d’activites Kennedy - 20, avenue Neil Armstrong – F-33700 Bordeaux-Merignac (France)
Tel +33 (0)5 57 928 928 – Fax +33 (0)5 57 928 929 –
www.ecreso.com – contact@ecreso.com
4.5
4.4
4.5
4.2.6
4.2.3
* Numbers above correspond to the paragraph numbers.