Ectaco Partner EPg400T User Manual - Setup
Partner
®
EPg400T User’s
Manual
18
9
The latest version of the PC-Link software and additional dictionaries can be
downloaded from Ectaco's web site at www.ectaco.com
Sending and Rec eiv ing
y
Connect the PC-Link cable to the PC-Link jack located on the right-hand
edge of the device.
y
Enter the PC-Link section.
y
Right click the PC-Link icon in the System Tray. In the PC-Link program,
select an appropriate data transfer mode.
9
Make sure to select an appropriate COM port.
9
Make sure you have no other PC-Link program running simultaneously with
EPg400T PC-Link.
y
Select the Send data transfer mode.Press ENTER.
y
Choose the section(s) you wish to send. Use SPACE to check or uncheck a
section.
y
Press ENTER to start the transfer.
9
Start the data transfer first on the receiving device, then on the sending
device.
y
To receive data, select the Receive data transfer mode. Press ENTER and
the transfer will begin.
9
The time span between the data transfer startup on the PC and the device
must not exceed 30 sec.
9
Note that in the Receive data mode, the newly transferred data will replace
all the old information saved in the corresponding sections of your device.
9
Always back up your important data! Neither the manufacturer nor the
dealers assume any responsibility for lost or corrupted data.
9
Data transfer consumes a considerable amount of energy. Using an external
power supply is strongly advised.
SETUP
Personalize your EPg400T and ensure good maintenance of your personal
records by selecting options in the Setup section.
y
Enter the Setup section.