ECX Torment ECX4000S Instruction Manual - Specifications
4
EN
CHARGING THE VEHICLE BATTERY
1. Attach the battery connector to the battery charger as shown.
2. Connect the battery charger to an AC power outlet.
3. Disconnect the battery from the charger as soon as the battery
is done charging.
4. Unplug the battery charger from the AC power outlet.
The vehicle battery charger produces 2.0 Amps 2000 milliAmps
per hour. Divide the mAh capacity on the label of a battery by 2000
to know how long battery charging will require. For example, an
1800mAh battery requires .9 hours (54 minutes) to charge.
CHARGING WARNINGS AND PRECAUTIONS
Failure to exercise caution while using this product and comply
with the following warnings could result in product malfunction,
electrical issues, excessive heat, FIRE, and ultimately injury and
property damage.
Transmitter
Frequency 2.4GHz
Battery
AA x 4
Servo
Power Supply
4.8V~6V (shared with receiver)
Output Torque
41.66 oz (3 kg-cm)
Operating Speed
0.23sec/60 degrees of travel
Size
55.6 x 18 x 30mm
Electronic Speed Control (ESC)
Input Voltage
4.8–8.4V
Electric Capacity (FET)
Forward 30 A/300 A
Electric Capacity (FET)
Reverse 15 A/150 A
PWM Frequency
1kHz
BEC Voltage
5.6 V/1 A
Size
46.4 x 36.9 x 28.25mm
Weight
76 g
SPECIFICATIONS
1. ECX
™
Torment
™
1/10-scale Short Course Truck
2. ECX
™
2.4GHz Transmitter
3. AA (4) Batteries
4. DYN4113 2A Peak Battery Charger
5. Dynamite
®
Speedpack
™
7.2V Ni-MH battery
(DYN1050EC)
COMPONENTS
1
2
5
3
VEHICLE PREPARATIONS
• Read all safety precautions and literature prior to use
of this product.
• Never allow minors to charge battery packs.
• Never attempt to charge dead or damaged batteries.
• Never charge a battery if the cable has been pinched or shorted.
• Never allow batteries or chargers to come into contact with
moisture at any time.
• Never charge batteries in extremely hot or cold places
(recommended between 50–80°F or 10–26°C) or place
in direct sunlight.
• Always use only Ni-MH rechargeable batteries. This charger
cannot charge batteries such as “heavy duty,” “alkaline battery,”
or “mercury battery.”
• Always connect the positive red lead (+) and negative black
lead (-) terminals of the battery to the charger terminals correctly.
• Always disconnect the battery and charger after charging
and let them cool between charges.
• Always inspect the battery before charging.
• Always terminate all processes and contact Horizon Hobby
if the product malfunctions.
• Always make sure you know the specifications of the battery
to be charged or discharged to ensure it meets the requirements
of this charger.
• Never connect more than one battery pack to this charger
at a time.
• Always constantly monitor the temperature of the battery
pack while charging.
• Always end the charging process if the charger or battery becomes
hot to the touch or starts to change form during the charge process.
4