Edco 2-EC Operator's Instruction Manual - page 11
Printed in USA
TVW
©2003
Page 11
E-2EC-2GC-411-I-1003
100 Thomas Johnson Drive, Frederick, MD 21702-4600 USA
Phone (301) 663-1600 • 1-800-638-3326
Fax (301) 663-1607 • 1-800-447-3326
Website: www.edcoinc.com • Email: sales@edcoinc.com
Threaded
Hub
Hub Stud
Pad Driver Disc
Silabide Pad
Flat Washer
Cap Screw
Non Spin Tab (3)
MULTI-DISC
This is a STRIP-SERT, rotate this blade to ex-
pose a new cutting surface. There are four (4) cut-
ting surfaces on each blade.
This is a DYMA-SERT, rotate the DYMA-SERT
only, not the case.
This is a Scarifier and does not require rotation.
THREE TYPES OF
ACCESSORIES
Accessory
case
Exploded view of Silabide Pad assembly.
SILABIDE PAD INSTALLATION
Installing Silabide Pads:
Install Hub Stud - one in each
threaded hub, this is a permanent installation and the stud need not be
removed when using the surfacer as a grinder or scarafier.
Be sure that the end of the stud, when fully threaded
into hub, does not project past web of multi-disc as-
sembly. Your surfacer is now ready to receive the PAD
DRIVER DISC anytime the need arises.
To install Pad Driver Disc:
Position PAD DRIVER DISC
against the web of the multi-disc, be sure “non-spin-tabs” are in place
(see illustration) in the center casting web to prevent disc from turning
loose. Be sure Pad Driver Disc is positioned flat against the casting.
Insert capscrew with flat washer through hole in Pad Driver Disc and
thread into Hub Stud. Tighten securly. Follow these instructions for
each disc assembly (refer to figure above).
Install Silabide Pads by pushing the pad against the bristles. The pad
should stay on the disc and the surfacer can then be lowered to it’s
normal position.
When using the surfacer as a scrubber, try not to lift the surfacer from
the slab except to remove or change pads. If the pad comes loose
from the disc, stop the surfacer and repeat Pad installation from step
#1 (disconnect the power source).
Spring loaded slot
Roll Pin