Summary of EDW-310BB
Page 1
Gps vehicle tracker edw-310bb user manual.
Page 2
Zy international limited gpstrackervt310bbmanual 1.Introduction........................................................................................3 2. Edw-310bb overview ……………………………………….……5 3. Specification ………………………………………………….. 12 4. Function ……… …………………………………………….. ..15 5. Get start ………………….....
Page 3: 1.Introduction
1.Introduction edw-310bb which come in a compact design is a powerful real time fleet management and vehicle tracking system using high sensitivity gps and wireless gsm/gprs communication. This self-contained and autonomous tracking device including gsm module, gps receiver, li- ion battery and mult...
Page 4: 2.Edw-310Bb Overview
2.Edw-310bb overview 2.1 edw-310bb unit edw-310bb is designed in a compact and simple rugged aluminum enclosure. At the end of the unit ,there are 2 led indicators shows the status of the unit. And various ports for vehicle interface, usb interface, external gsm/gprs antenna connector ,external gps ...
Page 5
2.2 led indicators logo led name description m gsm/gprs status indicator green led on: gsm/gprs connection status green led blinking: boot completion status green led off: idle status s gps status indicator orange led on: gps position fixed orange led blinking: during gps signal reception 2.3 connec...
Page 6
2.5 connect 2 please refer to the following table to understand the function of each pin at connect 3. Pin number description 1 digital input 1,also used as sos input * 2 digital input2 * 3 digital input 4** 4 digital input 5** 5 gnd 6 analog input 1 7 analog input 2 8 power 9 digital output1 10 dig...
Page 7: 3．specification
Gsm/gprs antenna, cables. The optional accessory including :hand-free kit, mobile data terminal, ccd camera, rfid reader, temperature sensor, tank fuel level sensor. For more details about optional accessory ,please refer to “ gps avl accessory guide v2[1].0” 3．specification 3.1 software features sm...
Page 8
External gsm/gprs antenna gps antenna indication:2 led indicator for gsm/gprs and gps status 3.3 technical specification gsm/gprs specification frequency bands simcom 300d:900/1800/1900mhz simcom 340d: 850/900/1800/1900mhz gsm class small ms transmit power class 4(2w) at egsm900 and gsm850 class 1(1...
Page 9: 4. Function
4. Function edw-310bb is able to be powered from 10v to 32v dc. The vin,gnd and ignition line of the vehicle port should be connected with the vehicle to use car management. The vin line should be connected to +12v or +24v dc of vehicle parts using 2a fuse, for example the vehicle battery. And also ...
Page 10
Via gprs packet at time interval. The time interval can be preset by customer thru gprs/sms/uart configuration cable. - sms and gprs mode when the control center connect with gsm modem and internet ,the control center communicates with the device through both gprs packet and sms at time interval. Th...
Page 11
4.4 status detection function the multi analog/digital input of edw-310bb make device easily connect with various sensor ,such as temperature sensor, rfid reader, tank fuel sensor and ccd camera. The info from sensor can be stored or send thru gprs according to customer’s preset. For more info about...
Page 12: 5. Get Start
4.8 mileage report function 5. Get start edw-310bb will only accept commands from a user with the correct password. Commands with wrong password are ignored. The default password is 000000. 5.1 basic sms commands 5.1.1 position report to know the location of your edw-310bb, send an sms or make a tel...
Page 13: 5.2 Gprs Settings By Sms
5.1.2 set interval for automatic timed report description: automatic timed reports will be sent to your mobile phone according to the time interval you set. Command: w,002,xxx notes: xxx is the interval in minute. If xxx=000 it will stop tracking example: sms sent: w000000,002,005 sms received: set ...
Page 14
Edw-310bb will reply with an sms (like ‘set apn ok/cmnet’) to confirm this setting. 5.2.3 set ip address and port 5.2.4 set time interval for sending gprs packet command: w,014,time interval(in unit of 10 seconds) (move mode: vibration ) example: w000000,014,00003 edw-310bb will send gprs packet eve...
Page 15: 6 Troubleshooting
5.3 device installation 5.3.1 connect the external gsm antenna and gps antenna 5.3.2 open the rear cover and then insert sim card 5.3.3 connect the analog port & cables with the device and the vehicle. The vin ,gnd and ignition signals of the analog port should be connected to the vehicle. If these ...
Page 16
Sms format format the sim in edw-310bb has run out of credit replace or top up the sim card no sim card insert working sim card. Check in phone that the sim can send sms message. Sim card has expired check in phone that the sim can send sms message. Replace sim card if needed. Sim has pin code set r...
Page 17
7 sms command list (remarks: ****** is user’s password, and the default password is 000000) command format remark get current location w ****** ,000 get current location of unit get current location w ****** ,001,****** ****** is old password ###### is new password set interval for automatic timed r...
Page 18
Alert set over speed alert w ****** ,005,xx xx (the preset value of speed) =00 , to turn off this function =[01, 20] (unit: 10km/h) for example, w000000,005,08, it will sent alert when it is over 80km/h set geo-fence alert w ****** ,006,xx xx ( preset distance to original place ) =00, close =01, 30m...
Page 19
0 c=0, turn off the function to automatically hang up an incoming call. C=1, turn on the function to automatically hang up an incoming call after 4 - 5 rings. D=0, turn off the function of sending an sms when unit is turned on. D=1, turn on the function of sending an sms to sos number when unit is t...
Page 20
Apn defaulted as ‘cmnet’; apn+apn name + password not over 39 characters.(default: cmnet） set ip address and port w ****** ,012,ip,port ip: xxx.Xxx.Xxx.Xxx port： [1,65534] enable gprs tracking function w ****** ,013,x x=0 closegprs（default） x=1 open tcp x=2 open udp set time interval for sending gpr...
Page 21
Minute. Example: if xx=10, edw-310bb will enter power saving mode after it is immobile for 10 minutes. Set phone number for wiretapping(optional ) w ****** ,030,t t is the telephone number for wiretapping and max. 16 digits set interval for logging( edw-310bb) (note: this interval is not relevant to...