Eddylight DSY-LED252-IP65-RGB User Manual - 9.Xlr Cable Connecting
EventDecorDirect.com | 1.888.592.0224
¾
Master/Slave
Master:The master should always working as a master as long as it is not set in a DMX mode
whatever other modes it is. And it send out the signal so that the slave synchronous with it. To avoid
the host signal and DMX512 signals interfere with each other, should cut off the DMX512 signals. The
signal lines are longer than 60 meters(20 lamps) ,should increase a signal amplifier.
Slave:he Slave must be set in DMX mode and the address code should be A001, to assure
receive the master’s signals correctly. Only one light can be set as a Master and others are slaves.
Note:
This product uses input and output power cord 0.75 m㎡copper core wire, power
line in series, when 220V AC should less than 35 lights, and 110V AC less than 20 lights! ! !
9.XLR cable connecting
¾
XRL cable:
The stand connection way of the XRL is: one end connect to the male plug ,and the other
connect to the female.