Summary of Carbolite 2000
Page 2
To a culture that survived for thousands of years with no adverse effects on the planet. It is a very special feeling. Kayaks leave no footprints and no trail. This is one of their special characteristics. Please be sure to do the same. Leave no trace of your presence as you venture into these new w...
Page 3
Cockpit rim oval hatch cover deck lines 4 pt. Self rescue lines spare paddle holder retractable carry handle bulkhead bulkhead 10” round hatch cover skeg end cap end cap deck tie down perimeter lines 8” day hatch cover skeg control knob retractable carry handle.
Page 4
Material information carbonlite 2000 combines many of the best qualities of fiberglass and plastic materials. Carbonlite 2000 has high uv resistance. Deterioration rate in intense sunlight is far better than conventional plastic materials. Light scratches can be rubbed out with plastic polish and ev...
Page 5
The infinity seat has 3 inches of adjustment forward and back allowing the paddler to change position relative to the thigh pads for the best fit. The backrest and backband fold forward and are spring loaded to stay in the upright position. This system is comfortable for extended paddling trips and ...
Page 6
Deck rigging the stern 4 point system is used for the paddlefloat self rescue technique. (see safety information) these cords work in conjunction with our backfloat or any other paddle float device to stabilize the kayak while you get back in. The optional backfloat however, has a dual purpose. It a...
Page 7
Cleaning the exterior a water rinse is often sufficient. Waterborne scum can be removed with soap. Use mr clean magic eraser sponges or a mild solvent like alcohol or naphtha to remove stubborn stains. Never use acetone on carbonlite 2000. You can polish your boat as often as you like although a few...
Page 8
Then check that the cable tubing is secured in its connections at the skeg housing and recess. Those points have compression fittings. If the tubing is free of the fitting, reinsert the tubing by pushing it in firmly through the ring and seat it into the fitting. You can also remove the cork and flu...
Page 9
Carbonlite 2000 repair see detailed repair information with pictures and vidoe at http://www.Eddyline.Com/eddyline-kayaks/care-repair/ carbonlite kayaks are easy to repair. The method used varies somewhat with the extent of the damage. Adhesives that bond: methyl methacrylate –( devcon plastic welde...
Page 10
3. Mix enough adhesive to coat the damaged edges and to fill exterior gouges. 4. Apply a thin layer of adhesive to as much of the damaged edge as possible. 5. Realign the edges and push them together. 6. Use tape to hold the pieces tightly together until the adhesive sets. If adhesive squishes out, ...
Page 11
Leaks how to repair leaks in your kayak: unless your kayak has a crack, leaks primarily occur in the following areas: seams, ends, hatch rims, bulkheads, skeg housings or fittings. Eddyline kayaks are all water tested before leaving the factory. However over time, leaks can develop from various sort...
Page 12
Seating configurations seating as a traditional tandem - bow and stern. The stern seat fits under the two tabs at the back of the seat and the stainless pin attaches the front of the seat to the track. The bow seat attaches with a pin both front and back. Seating paddlers facing each other. Bow seat...
Page 13
Shasta center paddler rudder control steps to set up center rudder control 1 .Remove the two seat pins and lift out the front seat 2.Remove the elastic bungie from the stern foot pedals (a) and unhook the cable from the metal foot rail (b) 3.Remove the rear pedals by sliding them out the rear of the...
Page 14
Shasta center paddler rudder control steps to set up center rudder control, cont. 5..Be sure to route the cable extension behind the side strut.. (e) e g f 6. Put in the foot pedals and rail from the front of the track. (f) 6. Attach the cable over the bolt. (g).
Page 15
H i 7. Attach the elastic loops to hold tension on the cables. (h, i) 8. Lock the seat in one of the two center positions with the two pins. Completed hook up shasta center paddler rudder control.
Page 16
If the ferrule is too tight, we recommend sanding the ferrule using 400 grit sand paper and water. Rotate the male ferrule in your hand while cupping it with sandpaper and sliding it back and forth. Try to sand evenly all around the tube and rinse frequently. Sand a little, clean it and try the fit ...
Page 17
Before you go ...... A guide to safe paddling from the trade association of paddlesports we'd like to welcome you to sea kayaking with a word of caution. It can be a safe and rewarding activity if common sense prevails and certain precautions are taken. Before you put in for a day's paddle, check th...
Page 18
Precautionary notes: make sure you are familiar with how to deal with the following situations, which can occur in open water. Consult local experts or available literature for additional information on these important subjects. A.Weather 1.Wind avoid paddling when whitecaps are visible until you th...
Page 19
Further study: see the suggested reading list at the end of fundamentals of kayak navigation by david burch for a comprehensive list of information sources. There are too many good books on the subject of understanding and forecasting weather to list here. Weather planning is a fundamental part of b...
Page 20
All eddyline carbonlite 2000 kayaks are covered under warranty against any defect in materials and workmanship for a period of three years from the date of purchase. This warranty is limited to the original owner and is only in effect if the warranty registration card is returned. Paddles and other ...