Edelbrock 17932 Installation Instructions
Catalog #17932
Brochure #63-0222
Page 1 of 4
©2003 Edelbrock Corporation
Rev. 11/03
255 Liter/Hr, In Tank Fuel Pump
For 1985-1997 Ford Mustang (Except for 1996-1997 Cobra)
Catalog # 17932
INSTALLATION INSTRUCTIONS
•
PLEASE study these instructions carefully before installing your new In-Tank Fuel Pump for 1985-1997 Ford Mustang
(Except 1996-1997 Cobra). If you have any questions or problems, do not hesitate to contact our
Technical Hotline at:
1-800-416-8628, from 7am-5pm PST, Mon-Fri, or via e-mail at: Edelbrock@Edelbrock.com. Please fill out and mail
your warranty card.
•
Note: Proper installation is the responsibility of the customer. Improper or incomplete installation could result in poor
performance, related component damage, potential severe engine damage, vehicle fire, and will void your warranty. If you
do not feel comfortable installing these parts, we recommend having the installation performed by a professional mechanic.
•
Description: This in-tank fuel pump replaces the factory pump and has an increased flow of 255 liters/hour (67 gph).
This in-tank upgrade pump is ideal for supporting performance improvements such as a big-bore throttle body, high
performance intake manifold, camshaft, supercharger, direct port nitrous system, etc. They replace your original pump
exactly and include all necessary hardware for an easy installation:
INSTALLATION NOTES
•
Remember: When working on your vehicle, especially when oil or fuel is present, always work in a well -
ventilated area. Keep all sparks, open flames, or other sources of ignition away from the work area. Failure
to do so could result in a fire or explosion causing vehicle or property damage, personal injury, and/or death.
•
Before Beginning: This installation can be accomplished using common tools and procedures. However, you should have
a basic knowledge of automotive repair and modification and be familiar with and comfortable with working on your vehicle.
If you do not feel comfortable working on your vehicle, it is recommended to have the installation completed by a
professional mechanic. Using a factory service manual for your vehicle for reference is helpful.
•
Note: Steps shown in these instructions are intended as a general guideline only. If you are not an experienced mechanic,
you should have a copy of your service manual on hand. The installation procedure for replacing your factory fuel pump is
covered in full detail in your factory service manual.
Minimum Tools Required:
1. Lift or appropriate jack
2. OSHA-approved jackstands
3. OSHA-approved fuel transfer pump
4. OSHA-approved fuel storage containers
5. Wire stripping and crimping tool
6. Various hand tools
Kit Contents:
Qty.
Description
❑
1
Fuel Pump
❑
1
Fuel Pump Filter
❑
1
Fuel Pump Isolator
❑
1
Fuel Tank to Pump Bracket O-Ring
❑
1
Electrical Connector
❑
1
Section of Pre-Formed Fuel Hose
❑
1
Hose Clamp
❑
1
Fuel Line Retaining Clip (1/4”)
❑
1
Fuel Line Retaining Clip (5/16”)