Edelbrock 5229 Installation Instructions

Catalog #5229

Rev. 2/05 

©2005 Edelbrock Corporation

Brochure No. 63-0333

Page 1 of 2

PLEASE study these instructions carefully before installing your new strut tower brace.  If you have any questions or

problems, contact our 

Technical Hotline at: 1-800-416-8628  from 7:00 am t- 5:00 pm, Monday-Friday, Pacific

Standard Time or e-mail us at:  Edelbrock@Edelbrock.com.  Please fill out and mail your warranty card.

• Application: Designed for 1998-02 Camaros and Firebirds with 5.7 LS1 V8.  This strut tower brace is much more

effective than other brands because it triangulates the front sturt towers to the vehicle firewall.  The firewall mounting

point virtually eliminates all strut tower flex by transferring sideload into two mounting points instead of just one.

• Tools Needed: In addition to common hand tools, you will need 9/16" wrenches, 15mm deep socket, 13mm socket,

#50 torx bit socket, a drill, and 3/8" drill bit.

• NOTE: On vehicles with automatic transmissions, the transmission dipstick will end up between the two main brace

tubes.  The dipstick tube may need to be slightly repositioned for better fit.  This can be done by taking a piece of tubing

large enough to slip over the dipstick tube and bending the end of the dipstick tube up and toward the passenger side,

while holding the back of the transmission tube.  Be careful not to kink the transmission dipstick tube.

Strut Tower Brace for 1998-2002 Camaros/Firebirds 

Catalog #5229

INSTALLATION INSTRUCTIONS

1. Remove the nuts and bolts on top of each strut tower

that will locate end brackets (use end brackets for

reference) of the strut tower brace.  Position end

brackets onto strut towers (as shown).  

DO NOT BOLT

DOWN AT THIS TIME.

2. Pop up plastic covers on wiper arms and remove nut.

NOTE:  Wiper arms will need to re-installed in the

same position as removed.

3. Remove plastic shrouding to gain access to the wiper

well.  This will make installation much easier.

4. Position the main brace assembly, as shown.  Install

the 3" bolts into the end of the main brace.  Align the

strut tower brace assembly and end brackets to locate

the position on the firewall that will need to be drilled.

Mark the firewall, then remove main brace assembly

and drill two 3/8" dia. holes in the firewall.

5. Re-install the main brace assembly into position.

Install the reinforcing plate into the wiper well area.

NOTE: R.T.V. silicone can be used on reinforcing plate

to hold in place for future removal of the main brace

assembly.

6. Install the two 1" bolts with flat washers and lock

washers supplied into firewall reinforcing plate, do not

tighten.  Install 3" bolts, nylock nuts, and flat washers

(flat washers go against head of bolt) into end brackets

and main brace.  Re-install the stock nuts and bolts on

top of strut towers.

NOTE: Check for clearance between strut tower brace

and any underhood components, A/C lines, cable,

hoses, etc.

7. Align the strut tower brace assembly.  Tighten the

factory strut tower nuts and bolts first, then tighten the

3" bolts on the main brace.  Finally, tighten the firewall

reinforcing plate bolts.

• NOTE: To further upgrade your F-body suspension,

use other quality Edelbrock suspension products such

as springs, shocks, torque arm, panhard rod, subframe

connectors, and lower trailing arms.

INSTALLATION