Edelbrock 5276 Installation Instructions
Page
1 of 2
©2007 Edelbrock Corporation
Brochure No. 63-0454
Catalog #5276
Rev. 9/07 - DA/mc
EDELBROCK LOWER TRAILING ARMS
for 2005-2008 Ford Mustang
Catalog #5276
INSTALLATION INSTRUCTIONS
®
Please study these instructions carefully before installing your new Trailing Arms. If you have any questions, please
contact our Technical Hotline at: 1-800-416-8628, 7:00 am to 5:00 pm, Monday through Friday, Pacific Standard Time
or e-mail us at Edelbrock@Edelbrock.com.
Application: Designed for 2005-2008 Ford Mustang vehicles. These trailing arms are designed to stabilize the rear
suspension, while improving suspension articulation.
Suggested Tools for Installation:
❑ Jack and proper load rated jackstands
❑ Blue Locktite
❑ Tire chocks
❑ Torque wrench
❑ Lug wrench
❑ Grease gun
❑ 18mm socket and combination wrench
1.
Place vehicle on level surface and place tire chocks
in front of and behind front tires.
2.
Support rear of the vehicle on the jackstands and
remove the rear wheels
(See Figure 1)
.
3.
Place a floorjack under the differential and lift up
slightly to remove tension from the trailing arm
bolts. Make sure not to lift the vehicle off the
jackstands
(See Figure 1).
NOTE: Keep floorjack under vehicle during
the complete removal and installation
procedure.
REMOVAL OF STOCK TRAILING ARMS
Fig. 1
CAUTION: Do not remove both trailing arms
at the same time or the axle will rotate and
the trailing arm installation will be much
more difficult.
4.
With parking brake released, remove clip from
parking brake cable at brake caliper. Slip cable
out of brake caliper and off of parking brake
arm. Thread cable back through trailing arm
(See Figure 2).
5.
Remove trailing arm bolts and trailing arms
(See Figure 3).
6.
Clean attachment points with a wire brush.
Fig. 2
IMPORTANT NOTE:
Proper installation is the responsibility of the installer. Improper installation will void warranty and may
result in poor performance and engine or vehicle damage.