Edelbrock 5282 Installation Instructions

©2005 Edelbrock Corporation

Brochure No. 63-0482

Page 1 of 3

Catalog #5282

Rev. 12/05 - DA/mc

ADJUSTABLE TORQUE ARM 

for 1984-2002 Camaro / Firebird

Catalog #5282

INSTALLATION INSTRUCTIONS

Please study these instructions carefully before installing your new adjustable torque arm.  If you have any questions,

please contact our 

Technical Hotline at: 1-800-416-8628, 7:00 am to 5:00 pm, Monday through Friday, Pacific

Standard Time or e-mail us at 

edelbrock@edelbrock.com.  Please fill out and mail your warranty card.

IMPORTANT NOTE:  Proper installation is the responsibility of the installer.

Improper installation may result in poor performance and engine or vehicle damage.

Application:  This torque arm is designed to fit 1984-2002 Camaro and Firebird with 1) US built, GM corporate 10 bolt

rear ends that have 7 ½" or 7 5/8" ring gear and, 2) with front torque arm locator lips facing away from driveshaft  

(See Fig. 1).

Fig. 1

PREPARATION CHECKLIST, TOOLS, AND EQUIPMENT REQUIRED:

❑

4 Post drive on vehicle lift recommended, or

❑

Drill with &/32 drill bit or grinder (to remove

❑

Floor jack and 4 properly rated jackstands

rivets)

❑

13mm, 15mm, 21mm, & 15/16” sockets and wrenches

❑

1-1/8” crows foot wrench (to properly 

❑

Torque wrench

re-torque adjuster sleeve jam nuts)

❑

Magnetic angle finder gauge

❑

Thread locking compound