Edelbrock 5670 Installation Instructions

©2006 Edelbrock Corporation

Brochure #63-0489

Page 1 of 2

Catalog #5670

Rev. 1/06 - DA/mc

EDELBROCK CAT-BACK EXHAUST SYSTEM

for 1994-1996 Impala SS with 5.7L V8 Engine

Catalog #5670

INSTALLATION INSTRUCTIONS

Application: Designed for 1994-1996 Impala SS with 5.7L V8 Engine.

Suggested Tools for Installation:

❑ 3/8” rachet set and metric sockets

❑ 15mm wrench

❑ Jackstands and jack

❑ Liquid penetrant and rubber lubricant

IMPORTANT NOTE:

Proper installation is the responsibility of the installer.  Improper installation will void warranty and may

result in poor performance and engine or vehicle damage.

Disassembly

1. Raise vehicle and support with the proper jackstands,

leaving the rear suspension hanging.

2. Use caution around hot exhaust systems to avoid

burns.

3. Use penetrating oil on all nuts, bolts and rubber

hangers.

4. If you are using a lift or jackstands, the old system can

be removed in one piece. Remove the nuts to the

catalytic converter pipes and remove the old muffler

assembly.

5. Remove the stock hangers behind the stock mufflers.

Assembly

1. Install supplied rear muffler hangers using stock

muffler hanger holes.

2. Install the left and right I-pipes to catalytic converter

and snug bolts (do not tighten at this time). Slip

mufflers onto I-pipe. Slip 2-1/2” band clamps on and

snug bolts.

Please study these instructions carefully before installing your new Cat-Back Exhaust System. If you have any questions,

please contact our Technical Hotline at: 1-800-416-8628, 7:00 am to 5:00 pm, Monday through Friday, Pacific

Standard Time or e-mail us at edelbrock@edelbrock.com. Please fill out and mail your warranty card.

WARNING: Exhaust gas contains carbon monoxide, a deadly invisible gas.  Correct any leaks before driving!

3. Install I-pipe bracket in factory location (on left side

transmission mount).

The two mounting bolts are

slotted to help you align exhaust system.

Do not

tighten at this time.

4. Slip a 2-1/2” U-clamp onto left I-pipe and snug pipe to

bracket installed in Step 2.

5. Slip the 2-1/2” U-clamps over the muffler outlets.

Install the overaxle pipe into the mufflers, slip on 2-

1/2” U-clamps and let hang on hangers.

6. Slip band clamps onto tailpie inlet end, then slip

tailpipes onto overaxle pipes.

Engage hangers on

tailpipes into stock isolators.

7. Using band clamps, install tailpipe tips onto outlet of

tailpipe and snug clamps.

8. Align system to clear frame, heat shields, suspension,

etc., and tighten working from front to rear of vehicle.

NOTE: Bumper height may vary by as much as 1/2” on

different vehicles, so you may need to bend the rear

hanger to adjust for your vehicle.

9. Check for leaks and correct as needed.