Edelbrock 6601 Installation Instructions - page 3
Catalog #6601, #66011, & #66012
©2003 Edelbrock Corporation
Page 3 of 3
Rev. 8/03
KIT CONTENTS
Catalog #6601, #66011, & #66012
Qty.
Description
Qty.
Description
1
Manifold left side (#25-9080)
4
Hex capscrews; 3/8” x 2”
1
Manifold right side (#25-9081)
2
Hex nuts; 5/16”-18
1
Extention pipe - left (#25-9594)
2
Hex bolts; 5/16”-18 x 1-1/4”
1
Extension pipe - right (#25-9595)
4
Lock washers; 3/8”
12
Hex header bolts; 5/16” - 18” x 1”
14
Lock washers; 5/16”
2
Chrysler V8 port gaskets
8
Flat washers; 5/16”
1
EGR gasket
1
EGR block-off plate #79-8051 (for 1996 only)
2
Donut gaskets; 2-1/4”
Edelbrock Corporation
2700 California St.
Torrance, CA 90503
Tech Line: 1-800-416-8628
E-Mail: edelbrock@edelbrock.com
Figure 1
Side view of catalytic converter
Figure 2
Side view of converter/headpipe connection
Oxygen Sensor Location
Cut 1/2” in front of weld
Donut Gasket
Make sure the spacing is
equal all the way to
ground connection