Edelbrock 6607 Installation Instructions

Catalog #6607

©2003 Edelbrock Corporation

Page 1 of 3

Rev. 12/03

TUBULAR EXHAUST SYSTEM

For 1995-1998 Toyota Tacoma, 4-Runner 

with 3.4L V6, Auto & Standard Transmissions

Catalog #6607

INSTALLATION INSTRUCTION

Please study these instructions carefully before installing your new  Tubular Exhaust System (TES).  If you have any

questions or problems, please contact our 

Technical Hotline at : 1-800-416-8628 from 7 am - 5pm, Monday-Friday,

Pacific Standard Time or e-mail us at 

edelbrock@edelbrock.com.

TUBULAR EXHAUST SYSTEM: This stainless steel Tubular Exhaust System header is designed to improve the exhaust

efficiency of the Toyota 3.4L V6 engine.  A performance gain can be expected by the installation of the system.  

This

system does require welding for installation (see note below) and retains all O.E.M. emissions equipment.  These

Tubular Exhaust Systems are street legal in all 50 states.

Suggested Tools Needed for Installation:  This vehicle has some metric fasteners.

❑ 

Mig welder (recommended) or gas welder - Professional welding is highly recommended.

❑

3/8” rachet socket with extensions and universal 10mm through 15mm swivel sockets

❑ 

Combination set of open-end wrenches, SAE and metric

❑

14mm offset open-end wrench

❑ 

Jackstands, screwdrivers, pliers, crescent wrench, hacksaw, etc.

❑

Liquid penetrant, (GM #1052627) and anti-seize compound (GM #5613695)

SPECIAL NOTICE: This Edelbrock Tubular Exhaust System has received an Executive Order number (E.O.#) from the

California Air Resources Board (C.A.R.B.) making it legal for street use in all 50 states.  To assist you with emission

equipment certification, we have included a silver fan shroud decal to help testing personnel verify the this part is a legal

replacement on the vehicle for which it is cataloged.  The adhesive-backed decal should be affixed next to the existing

emission and engine specifications decal.  Do not cover any part of your original emission decal.

WARNING: The use of "Thermal Wrap" or any aftermarket coating process  will void the warranty on your Edelbrock

Tubular Exhaust Systems.  Those products can cause excessive heat and moisture buildup resulting in corrosion and

failure of the system.  

CAUTION: Due to higher underhood temperatures generated by TES, vehicles equipped with original spark plug wires

should have them replaced with high temperature plug wires for longer life.

NOTES:

1. The paint used on non-coated T.E.S. is for protection during shipping and storage and will burn off soon after the

engine is started.  Those who desire a longer lasting finish should sandblast the T.E.S. to remove the original paint,

then apply high temperature header paint, such as VHT, available at most auto parts stores.

2. When cleaning any Edelbrock Pro-Tech coated TES, use only soap and warm water.  The use of caustic solvents

(gunk, etc.) will mar or damage the Pro-Tech coating.

3. High temperature spark plug wires and boots are recommended to withstand heat from T.E.S.