Eden Navigator WP-100 Operation Manual

Other manuals for Navigator WP-100: Brochure, Operation Manual, Quick Start Manual
Manual is about: world tour series

Summary of Navigator WP-100

  • Page 1

    1 eden electronics operation manual world tour series preamplifier the navigator wp-100 bass preamplifier professional bass guitar preamplifier for live performance and direct studio recording interface applications. Revised 3-30-03 two year limited warranty.

  • Page 2: Caution!

    2 wp-100 operations manual forward congratulations, on the purchase of your new bass guitar preamplifier. This unit is all carefully hand built by eden electronics and is of the finest professional bass preamplifiers available today. The wp-100 offers a unique combination of vacuum tube and fet elec...

  • Page 3

    3 description of the front panel controls input jack the input is routed directly to the vacuum tube (7025) and will operate properly with any input signal level up to a maximum (+21 dbm) input level from the bass guitar. This eliminates the need for a separate input pad. Gain control the gain contr...

  • Page 4

    4 enhance bypass this switch allows the enhance control to be turned on and off by panel or foot switch. It's a great feature for doing a quick tone change while playing. As with the other controls the panel switch overrides or takes control from the foot switch. The red led will be on when the swit...

  • Page 5

    5 studio quality compressor the navigator's internal studio quality compressor uses a dbx style, state of the art compressor chip with a fully adjustable ratio and threshold. The recommended starting point for control settings is around 1:00 for the threshold control and around 11:00 for the ratio c...

  • Page 6

    6 treble control the treble control is also a shelving type filter and boosts or cuts the treble by +/- 15 db. Flat position is at 12:00 o'clock. Semi-parametric tone controls (quasi-parametric) quasi-parametric controls are similar to fully parametric controls with the exception that they do not ha...

  • Page 7

    7 side chain effects loop level control the side chain loop is configured to operate in parallel with the tone controls. This allows a special effect or signal to be added across or blended with the internal tone controls. The return level control allows the artist to blend the exact amount of effec...

  • Page 8

    8 master level control this is the final output level control. It controls both the main outputs, and the left and right d.I. Outputs. For normal use the master should run from around the 9:00 position to about the 12:00 position on the control. It is possible to put enough extra gain on the output ...

  • Page 9

    9 mains on / off this is the master power switch. It is always advisable to turn the master level control down during turn on and turn off. Automatic master muting systems on your navigator the main d.I.S left and right, and the left right 1/4" outputs are muted. The instrument d.I. Is also muted. F...

  • Page 10: Yourself.

    10 fuse holder ac inlet this is a standard iec connector interface. The fuse should be replace only with the same size and type. The correct fuse is 1 amp for the usa @ 120v. Contact you local distributor for all foreign voltage applic ations. The navigator is set up to work with most international ...

  • Page 11

    11 tuner output send the tune output send is direct from the vacuum tube and is not muted during any of the automatic or manual muting modes. It allows for a tuner to be plugged in at all times. This output is at the same relative level as the output of the instrument times 1 or unity gain. Foot swi...

  • Page 12

    12 normal set for the usa 120v 60hz : white (neutral )to p9, black to (ac hot ) p11. Japan 100v 60hz: white to p10 (20v) black(ac hot ) to p11. Western europe most ec counties and italy 240/230v 50hz: white (neutral) to p9 0v black (ac hot)to p12. Switzerland 220v 50hz: white (neutral) to p10 black ...

  • Page 13: Your Eq Settings

    13 good luck and enjoy playing with your new navigator. Service– in the event of amplifier malfunction, or questio ns about your unit’s operating features, you should contact the your dealer, the factory, or one of our authorized service centers for assistance. Call customer service @ 1-847-949-0444...

  • Page 14

    14 eden electronics division of us music 444 e courtland rd. Mundelein , il 60060 847-949-0444 847-949-8444(fax) please ship authorized returns for service to : eden electronics 115 second st. Montrose, mn 55363 763-675-1890 763-675-3777 (fax) email @ eden@eden-electronics.Com web sight @ http://www...