Eden Nemesis Silver Series NA120 Owner's manual - Na120 / Na80

Manual is about: Bass Guitar Amplifier Chassis For Silver Series Combos

Summary of Nemesis Silver Series NA120

  • Page 1

    1 nemesis silver series owners manual na120 / na80 bass guitar amplifier chassis for silver series combos covering models n10s(e), n12s(e) n15s(e), n28s(e) 3/15/2005 u. S. Music corp..

  • Page 2: Na120 / Na80

    2 na120 / na80 bass guitar amplifier chassis for all nemesis silver series combos models n10s(e), n12s(e) n15s(e), n28s(e) operation manual publishing date 3-15-05 foreword congratulations on your purchase of your new lightweight nemesis silver series combo amplifier system. All of us at eden are to...

  • Page 3

    3 the nemesis silver series products group is a revolution in bass guitar equipment and manufacturing technology. We have taken fet power device technology, computer-optimized circuit design, and years of research and testing to evolve our latest electronics package: the na80/120. This is a great st...

  • Page 4: Warranty Registration Card.

    4 please take the time to review this manual and to send in your warranty registration card. General features your nemesis silver series combo has all the following features: a 90 to 130 watt fet power amplifier @ 8 ohms, dual channels, heavy duty passive thermal cooling, extension speaker compatibi...

  • Page 5

    5 position. This will set your amplifier up flat and with the auto compressor operating. Next, plug in the power cord to the ac inlet on the back of the unit. Use only a safe grounded receptacle for proper operation at the correct voltage for your country. Double check to make certain your amplifier...

  • Page 6

    6 this control regulates the first amplification stage and controls the gain of the first stage in the overall system. The compressor automatically tracks the input level and follows the gain. This is a fixed-threshold type compressor. You control the compressor threshold by setting the gain higher ...

  • Page 7

    7 can also be used with the other tone controls. Main tone control 3-band eq main channel the main tone control section is a 3-band tone equalizer. The audio spectrum is divided into three bands, the bass, mid, and treble. The bass and treble are shelving type filters and the midrange control is a b...

  • Page 8: Back Panel Features

    8 this switch turns off your internal and external speakers for quiet practicing with the headphones. Back panel features ac power inlet/ fuse this is where you plug in your ac line cord. This is also where the fuse is located. The fuse for us operation is a 2 amp. 5x20 mm slow-blow type fuse. In eu...

  • Page 9: Do Not

    9 during the thermal standby. Your unit will come back on automatically in 1 to 3 minutes and operate normally. If the unit continues to cycle through thermal shutdown, you should contact your local dealer for service help. Heavy duty professional use the nemesis silver series combos are primarily d...

  • Page 10

    10 the d.I. Output is used to connect your unit to p.A. Systems and recording consoles. This is adjustable from microphone level to a high line level signal. The level control sets the amount of signal level that appears at the output of the xlr connector. The ground lift is used to reduce noise whe...

  • Page 11: For Your Safety

    11 speaker break in it is recommended that you play for a few hours at low to medium volume before you push your new combo to the max. This will extend the life of the speaker system. For your safety always use a correctly grounded receptacle for your amplifier ac receptacle. If your fuse should eve...