1 valvetech vt-300a all tube bass guitar amplifier users manual eden the standard in bass sound draft copy: 1-20-2000
2 congratulations on your purchase of this unique all tube amplifier. The vt- 300 was designed for those who love the great vintage tone and gentle acoustic color of the old tube amplifiers. This is a hand crafted amplifier built with modern construction techniques and reliable printed circuits by p...
3 front panel features input jacks designed to accept a standard ¼” mono phone plug. The passive jack is for use with low output basses and passive basses. The active jack is for higher output basses with active electronics. Overdrive control this switch shifts the amplifier into an ultra hi gain mo...
4 master level control this controls the final drive to the amplifier. Use this to control your stage level. About mid point on the control should be normal for most playing situations. Compressor active light this indicates the activity of the compressor. When the led lights up the compressor is fu...
5 back panel features ac power inlet this is the main ac connection point. It is an iec type inlet and also serves as the fuse carrier. Replace the fuse only with the same type and size as the original. Fx loop this loop is located post the tone controls and sit just prior to the amplifier input. Tu...
6 cooling system this unit uses a continuous flow cooling system that is always in operation when the power is on to the amplifier. Output tubes your unit comes from the factory set up and fully run in for 6550 type output tubes. Optional el-34 outputs can also be fitted to your unit. This requires ...
