1 wt-300 bass amplifier the traveler owner’s manual 9/30/98.
2 congratulations on your purchase of the eden wt-300 traveler bass instrument amplifier. You have purchased what we feel is one of the finest bass amplifiers in the world. The wt-300 produces 300 watts of pure power into 4 ohms (175 watts into 8 ohms) with 3db of dynamic headroom. The tube preamp s...
3 front panel features input jack – designed to accept a standard ¼ inch mono phone plug. For best results, use a high-quality, shielded cable to connect your instrument to the amplifier. Gain control – regulates the first gain stage of the preamplifier and controls the amount of signal available to...
4 compressor and enhance control and prior to the tone section. Recording out – this fully balanced xlr output allows you to send a post-eq/pre- master signal to a recording or sound reinforcement mixing console. This output is designed to allow use with phantom powered systems. D.I. Level – control...
5 your lower strings. If the action of the compressor seems premature or excessive for your taste, you can lower the gain control a bit to delay the onset of compression. Having set your initial level, you are now ready to proceed with setting up your tone controls. Since tone adjustments have an im...
6 accommodate the characteristics of your amplifier and your predominant application. If you will only be using one cabinet, a 4 ohm model will draw the most current from your amplifier. If you will generally be using two cabinets, they should be 8 ohm models so their combined impedance will be 4 oh...
7 eq settings setting name: _____________________ setting name :___________________ setting name: _______________________.
