EdenPURE PowerPack 4000 Owner's Manual - page 6
Basic Operating Instructions
•
Carefully remove your Bathroom Heater from its box and save it for off-season storage.
•
Make sure the Mode Control Knob is set to the OFF Mode before plugging the Bathroom
Heater into an outlet.
•
To avoid overloading your circuit, do not use other high wattage appliances in the same
outlet. At 1500 watts, this heater draws 12.5 Amps.
•
To start heater operation, make sure the thermostat is set to the highest position
Mode Controls
•
OFF Mode – To turn the Bathroom Heater off at any time, turn the Mode Control Knob to
the OFF position (indicated by the icon with the circle)
•
Fan Only Mode – To run the heater on Fan Only Mode (without heat output), turn the
Mode Control Knob to the Fan Only position (indicated by the icon with the fan)
•
Low Heat – The heater will run continuously on low heat
•
High Heat – The heater will run continuously on high heat at 1500 watts
Thermostat Control
•
Before setting the thermostat, allow the Bathroom Heater to operate and warm up your
room. As noted above, to turn on the unit, make sure the thermostat is set to the highest
position.
•
Once the desired temperature comfort level is reached, lower the thermostat setting
until the Bathroom Heater stops operating. This is done by moving the Thermostat Control
Knob to lower settings.
•
The thermostat will now automatically maintain the pre-set temperature by cycling the
heater ON and OFF.
•
Please note that it is normal for the Bathroom Heater to cycle on and off as it maintains
your preset temperature. To prevent the unit from cycling, raise the thermostat setting.