Emmaljunge Cerox Sportvagn Instructions For Use Manual - page 10
1
2
1
2
4
3
Manual Cerox v. 1.2
22
3
4
Unfolding the chassis
• Start by braking the pram.
• Pull the handle while you are holding one side of the chassis.
WARNING
• The chassis locks need to click into the locked position.
• The safety catch (secondary locking mechanism) is activated to
prevent unintentional folding if the chassis lock is not locked
into position.
• Please make sure, before you use the pram that the chassis lock is
in the locked position.
Assembly and usage of the chassis
Attaching the wheels
• Remove the plastic protection from the axles. Save them for
future use.
• Attach the wheels with the wheel cogs (1). Press in the hub cap’s
release button (2), push the wheel onto the axles as far as it can
go. Release the button and pull the wheel towards you, until
you hear a defi nite click. Repeat the same procedure for all four
wheels. Please make sure that the wheels are attached properly
and cannot be pulled off the axle.
• Release the brake by pushing the brake bar up towards you using
minimum force with your foot.
IMPORTANT
• The wheels are greased and can leave marks on textiles. Please
use wheel protection indoors to protect your fl oors.
• Risk of suffocation. Don’t let your child play with or in some
other way handle the plastic protections.
• Because of the infl uence of ozone and UV radiation the tyres may
develop small cracks due to the rubber drying out. This does not
affect the vehicle’s driving ability and safety and is not a reason
for complaint.
Braking the vehicle/releasing the brake
• Brake by pushing the brake bar down into the wheel cogs.
• Release the brake by lifting it upwards.
WARNING
• Never leave the child unattended without engaging the braking
system correctly.
• Ensure that the brake unit sits fi rmly in the wheel cogs.
• The brake should always be engaged when you lift your child in
and out of the vehicle.
• Never park the vehicle on a hill.
• The vehicle is equipped with cog brakes. Check that there is a
wheel cog on each wheel (four of them). Engage the brake only
when the vehicle has come to a standstill.
How to adjust the height of the handle
• Adjust the height on the handle by pressing the grey buttons on
the inside of the handle (3).
Keep the buttons pressed in while you adjust to the required
position (4).