Emmepi 702-IMD-3K Installation, Operating And Maintenance Instructions - page 15
Page 15
6.
STARTING UP
CAUTION: The heating zone is heated by the heat emanated by the base of the saucepan. To avoid burns
and injury, do not touch the heating zone.
a)
Connect the appliance to the power supply after making sure that the voltage corresponds to that used by the
induction generator and indicated on the manufacturer’s plaque.
b)
Place the saucepan directly above the cooking zone where the inductors are located.
c)
Turn the knob/potentiometer in a clockwise direction. To activate the power supply: the GREEN LED turns on.
Absence of the saucepan: the GREEN LED flashes.
d)
Select the desired power using the knob/potentiometer, which will set the power immediately.
When you remove the pan for awhile, the inductor will stop supplying power, and when you replace the pan the
power will be restored immediately at the same level as before.
For safety reasons, if the pan is removed for more than 600 seconds, the induction is switched off completely
and will need to be switched back on if the pan is replaced, restoring the knob/potentiometer to the “OFF”
position and then back to the desired power by turning the knob in a clockwise direction.
7.
SWTCH OFF
-
Turn the knob/potentiometer in a clockwise or anticlockwise direction until it is in the rest position [OFF]
-
Certain parts of the generator are still powered even when the cooker is switched off.
Therefore, if carrying out maintenance work, disconnect the appliance from the power supply first.
-
Make sure that no liquid penetrates the induction generator, either during normal use or during cleaning and
maintenance of the component.
8
CLEANING AND MAINTENANCE
CAUTION: During cleaning, do not wash the external parts of the appliance with direct or high pressure
water jets.
Every evening, after use, clean the appliance thoroughly.
Daily cleaning after switching off the appliance ensures the perfect functioning and long life of the appliance.
Before starting to clean the appliance, disconnect the power supply.
The steel parts must be washed with hot water and neutral detergent, then rinsed thoroughly in order to eliminate all
traces of detergent.
They should then be dried with a dry cloth.
Do not use abrasive or corrosive detergents.
8.1
CLEANING THE GLASS
The glass should be washed with vinegar or lemon-based degreasers, suitable for cleaning ceramics and glass.
During this operation, it is best for the glass not to be completely cold, so that spilt food, burnt fat and other substances
can be softened with a damp cloth and removed whilst still warm with a scraper, so as to prevent the glass surface from
deteriorating.
Do not use abrasive or corrosive detergents.
9.
PROCEDURE TO FOLLOW IF THE APPLIANCE IS NOT GOING TO BE USED FOR SOME TIME
Clean and dry the appliance carefully according to the instructions. Disconnect the power supply.