Emotiva UPA-700 User Manual - Gain:

Page 14

UPA-700

Input Sensitivity (for rated power; 8 Ohm load):

870 mV.

Gain:

29 dB.

Input Connections:

Unbalanced (RCA); one per channel.

Input Impedance:

47 kOhms.

Trigger:

Trigger Input: 5 - 20 V (AC or DC);

Trigger Output: 12 VDC; can drive any load up to 50 mA.

Power Requirements:

115 VAC or 230 VAC +/- 10% @ 50 / 60 Hz (automatically detected and switched).

Front Panel Controls and Indicators:

Standby; push button (changes color to indicate Standby or On). 

Status LEDs (one per channel); illuminate blue for normal operation or red to indicate a fault 

(may be disabled by rear panel Status LED switch).

Rear Panel Controls:

AC Power switch; rocker switch (switches AC mains power). 

Status LEDs switch; small slide switch on left (disables front panel Status LEDs and dims 

Standby button halo lighting).

Protection:

The UPA-700 is protected against excessive operating temperature, shorted speaker 

connections, ground faults, and other common fault conditions. If a fault occurs, the  

UPA-700 will return to Standby mode, the Standby button will light amber, and the Status 

LEDs will flash red.

Dimensions: 

17” wide x 6” high x 16-5/16” deep (includes feet and binding posts).

Weight:

29 pounds unboxed (39 pounds boxed).