EMP Tek CS100 Installation And Operation Manual - page 4
To obtain the best possible sound quality from your CS100 & CS100C speakers,
it is important to place the speakers where they will sound best in your listening
room. Your room will influence the balance, imaging and overall sonic quality of
the system, so you may want to experiment with speaker placement to determine
which location offers the best overall sound for each speaker. As a general guide,
use the room layout diagram and the following descriptions when setting up a
home theater system. Some speakers shown in the diagram may not always
be applicable to your individual system.
Front Main Left and Right Speakers
As a suggested starting point for the front left and right main speakers, try to
place your speakers about 5 inches away from the wall and 7 feet apart from
each other. The distance from the listening position to each speaker should be
System Setup
Attaching Mounting Bracket
A mounting bracket and the necessary hardware are included with the CS100 to
allow them to be mounted to a wall or speaker stand. Choose a suitable location
for the speakers, and use four screws to mount each bracket to the surface
of the chosen area. If mounting on drywall, use the four drywall wall anchors
(included) to increase the sturdiness of the mount. First, use a pencil to mark
the location of each of the four holes, and then use a Phillips head screwdriver
to screw the drywall anchors into the drywall. Then place the bracket against
the wall and use four screws (placing one in each drywall anchor) to fasten the
bracket to the wall. Place the speaker against the bracket, lining-up the speaker’s
threaded insert against the hole in the bracket, and use the Attachment Knob
to fasten the speaker to the bracket. Pay close attention to face the speaker in
the desired direction before tightening the Attachment Knob.