Empire P)-1 Installation instructions and owner's manual

INSTALLATION INSTRUCTIONS

AND OWNER'S MANUAL

CONTEMPORARY LINEAR 

VENT-FREE GAS FIREPLACE

MODELS

VFLL38FP(3,9)0L25(N,P)-1

VFLL38FP(3,9)0L(N,P)-1

VFLL48FP(3,9)0L(N,P)-1

MH46389

GAS-FIRED

Vent-Free Linear Logset Shown

This appliance may be installed in an after-

market permanently located, manufactured 

(mobile) home, where not prohibited by local 

codes.

This appliance is only for use with the type of 

gas indicated on the rating plate. This fireplace 

is not convertible for use with other gases.

Installer: 

Leave this manual with the  

appliance.

Consumer:  Retain this manual for future 

reference.

WARNING: If the information in these 

instructions are not followed exactly, a fire 

or explosion may result causing property 

damage, personal injury or loss of life.

— Do not store or use gasoline or other 

flammable  vapors  and  liquids  in  the  

vicinity of this or any other appliance.

—  WHAT TO DO IF YOU SMELL GAS

  •  Do not try to light any appliance.

  •  Do not touch any electrical switch; do 

not use any phone in your building.

  •  Immediately  call  your  gas  supplier 

from a neighbor’s phone. Follow the 

gas supplier’s instructions.

  •  If you cannot reach your gas supplier, 

call the fire department.

— Installation and service must be per-

formed  by  a  qualified  installer,  service 

agency or the gas supplier.

This is an unvented gas-fired heater. It uses 

air (oxygen) from the room in which it is  

installed. Provisions for adequate combustion 

and ventilation air must be provided. Refer to 

pages 13 - 14.

WARNING: If not installed, operated and 

maintained in accordance with the  

manufacturer's instructions, this product 

could expose you to substances in fuel or 

from fuel combustion which can cause death 

or serious illness.

WATER VAPOR: A BY-PRODUCT OF 

UNVENTED ROOM HEATERS

Water vapor is a by-product of gas combus-

tion. An unvented room heater produces 

approximately one (1) ounce (30ml) of water 

for every 1,000 BTU's (.3KW's) of gas input 

per hour. Refer to page 13.

Page 1