EZ DELUXE Operation & Installation Manual

Manual is about: Water Controlled Electric Ignition

Summary of DELUXE

  • Page 1

    Ez deluxe operation & installation manual ez tankless.

  • Page 2

    Ez deluxe tankless water heater specifications maximum gas consumption btu/h hot water supply at 45f temperature rise lpg (propane) ng (natural gas) ignition system electric supply safety devices suitable inlet water pressure water connection gas connection exhaust system 87,500 3.4gpm 11” wc 8” wc ...

  • Page 3: Table of Contents

    1.0 limited warranty 2.0 what’s included? 2.1 product features and benefits 3.0 safety precautions 3.1 hot water risk 3.2 first aid 4.0 initial setup and operation 5.0 recommended maintenance procedures 6.0 troubleshooting 7.0 informational drawings 8.0 contact us note: please ensure that the conten...

  • Page 4: 1.0 Limited Warranty

    What is covered? The ez tankless warranty covers any defects in materials or product workmanship when the product is installed and operated in accordance with written installation instructions contained herein, subject to the terms outlined within this limited warranty document. This warranty is app...

  • Page 5: 2.0 What’S Included?

    2.0 what’s included? 1 x ez tankless water heater 2 x 1/2” npt bushings 1 x 3/4” npt bushings page 04. Ez tankless deluxe operation + installation manual.

  • Page 6: 2.1 Features and Benefits

    2.1 features and benefits • the ez deluxe features our advanced sealed double-chamber forced air intake - exhaust system • fully-automatic operation. Once installed, simply turn on the water spigot or shower–instanteous hot water will arrive in a few moments. After the tap is turned off, the tankles...

  • Page 7: 3.1  Hot Water Risk

    01. Always check water temperature by hand before entering shower or bath. The temperature may have been changed. Do not touch the unit cover or the flue outlet while in use. 02. Do not insert objects into the flue outlet. On colder days steam may discharge from the flue outlet. This condition is no...

  • Page 8

    1. On/off switch turn the systems power on. Display will light up with temp. 2. Initial temperatue setting: between 40-50c 3. Water source inlet water source should be at least 1 gpm filtered water at a minimum of 8psi. Lower water flow or a lower water pressure may result in unit failing to ignite....

  • Page 9

    1. Well water installations due to the fluctuation in water pressure when using on a well water system, users may experience fluctuations in water temperature. Fluctuations can be rectified with use of a water pressure regulator. When using a well system with a pump switch set to 40-60psi, it is bes...

  • Page 10: Ez Tankless Water Heaters

    Ez tankless water heaters ez-deluxe: domestic hot water - standard installation schematic key 3/4" ball valve 3/4" union xxxxx pressure relief valve boiler drain valve this drawing is not an engineered drawing. It is intended for use only as a guide and does not act as replacement for professionally...

  • Page 11

    1. Check the gas hose and regulator for any defects propane regulators, especially single stage regulators, defect at a high rate predominantly due to age. Most single stage regulators will eventually allow a higher pressure than the required 11”wc by the ez deluxe. When this happens the unit will n...

  • Page 12: 6.0 Troubleshooting

    Q1. When the hot water tap is opened, and the ez deluxe is not responding. A. If you are running water through the system, but do not see a showerhead image on the display, the heater is failing to sense the water flow. This will require one of the following to resolve the issue: 1. Flush the unit. ...

  • Page 13

    Q5. The display shows an ‘e4’ error code when trying to ignite. A. This is an error in the fan sensor, fan motor, or motherboard. Remove the front cover of the ez deluxe, keep- ing the display wires attached. Locate the fan in the bottom left corner of the unit. Run a hot water tap. Watch the fan bl...

  • Page 14: 7.0 Informational

    7.0 informational drawings page 13. Description a b c d e 1 e 2 e 3 13-7/8” or 351mm width depth height - unit height - including brackets hot water outlet (from wall) 4-7/8” or 125mm 22-7/8” or 566mm 24-5/16” or 618mm 3/4” of 20mm 1-3/4” or 42mm 2-1/4” or 52mm dim ez tankless deluxe operation + ins...

  • Page 15: Contact Us

    Ez tankless, inc. 120 n washington ave fowler, in 47942 sales department: e. Sales@eztankless.Com p. 219-369-4781 support department: e. Support@eztankless.Com p. 765-885-5125 contact us page 14. Ez tankless deluxe operation + installation manual.