EZ Digital FC-3000 Operation Manual - Caution

10 

1-4. Supplied Accessories 

  Operation Manual ----------------------------------------------------------------------------- 1 

  BNC cable -------------------------------------------------------------------------------------- 1 

  Power cord-------------------------------------------------------------------------------------- 1 

  Spare Fuse-------------------------------------------------------------------------------------- 1 

Specifications are subject to change without notice. 

2. INSTALLATION 

2-1. Initial Inspection 

  This instrument was carefully inspected both mechanically and electrically before 

shipment. It should be physically free of damage. To confirm this, the instrument 

should be inspected for physical damage in transit. Also, check for supplied 

accessories. 

2-2. Connecting AC Power 

  This instrument requires ac 230V 50-60 Hz power through 3-conductor ac power 

cable to be fit into three-contact electrical outlet to secure grounding. If forced to use 2-

conductor cable, use ground terminal in rear panel for grounding instrument. 

CAUTION

THIS INSTRUMENT IS SET TO AC 230V. BEFORE POWERING ON THIS 

INSTRUMENT, MAKE SURE THE VOLTAGE OF THE POWER SOURCE IS AC 

230V. 

2-3. Cooling and Ventilation 

  No special cooling and ventilation is required. However, the instrument should be 

operated where the ambient temperature is maintained. 

2-4. Position 

  This instrument is built as a bench-type instrument with rubber feet and tilt stand in 

place. Stand-up angle can be adjusted by rotating angle of carrying handle. 

2-5. Warming-Up 

  Allow more than 20 minutes for the unit to warm up so that it is stabilized and ready 

for use.                             

Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176

FAX 781.665.0780 - TestEquipmentDepot.com