EZ Heat Basic Installation Manual - page 4
Figure 3
Before you start, be sure you have the following:
a.
Two flexible filter hoses: One long enough to reach between the
return fitting at the pool and the outlet fitting on the solar system and
the second long enough to reach between the filter outlet fitting and
the solar system inlet fitting. (Or sufficient pipe and fittings.)
b.
An EZ Heat Hose Connection Kit or adapter fittings. Use part #1005
for connecting to 1-1/2” hoses. If you are using rigid pipe connections,
connect to the piping with 1½ inch male pipe thread to slip adapters,
available from pool dealers or plumbing supply stores.
c.
A plug for the pool return fitting
Next, make a note of the pressure reading on the filter gauge with the
pump running and a clean filter. Shut off the power to the pump and plug
the return fitting at the pool to prevent loss of water from the pool.
Install the Hose Connection Kit. Wrap one layer of the supplied pipe joint
sealant tape around the threads, starting at the end and wrapping
clockwise. Tighten the fitting firmly, but do not over tighten. Connect the