EzCAP EzCAP3104B Instruction Manual - page 2
Monitoring Software WistionDVR
Dimension / Weight
90(L)
×59(W)×22(H)mm / 108.5g
One available USB port
Pentium4 1700MHz CPU or above
512MB RAM or above
80GB free HDD space
CD-ROM for installation
Windows 2000, XP, Vista, Seven
System Requirements
DirectX 9.0
Hardware installation
4 Channel USB DVR Hardware
Note:1, Make sure that your PC USB interface is 2.0; this card can only support USB 2.0.
2, Please according to the following steps to safely remove the USB card: Right clicks on the
Taskbar Stop device pull out the USB card.
3, Using this card with other USB device simultaneously may cause PC cannot identify USB card.
4, Do not insert two or more USB video capture cards simultaneously.
5, Do not use with the other PCI video capture card simultaneously.
6, Before installing the 4 Channel USB DVR hardware in PCI port of the motherboard, make sure
you
’ve installed Microsoft DirectX 9.0. Then turn on the computer, the system will remind you to “Found
new hardware
”.
7, Just click
“cancel” and ignore the pop-up message.
Install 4 Channel USB DVR Driver:
Note: 1, If you have any antivirus software enabled, please disable it during the installation of the
software.
2, Please plug your EzCAP3104B device into your computer
’s USB2.0 port before you try to install
the device driver.
3, If your OS is 64-bit, please press F8 and select
“Disable digital signature Enforcement” to enter
the OS when you start the computer,
Please insert the Software CD into your CD drive, you will get a window,( If you can
’t get it, please open the
installation CD and run
“autorun.exe”) select “Install Driver”.
Audioinput (white/red)
Video input (yellow)
USB Connection