Ezee Glider Manual

Page of 8

Download

Print this page

Bookmark us

EZee Glider Manual

Congratulations on your purchase of the EZee Glider! Your glider is designed for years of nearly carefree use by

your child. These instructions include how to set up your glider and the maintenance procedures which you should

perform to ensure long-lasting use and optimal performance

Tools needed for Assembly:

Wrench (included)

Philips Screwdriver (not included)

Assembly Instructions

Your Glider comes partially assembled. The only things that you need to do are install the front wheel, install and

adjust the handlebars, and put in the seat.

Installing and Adjusting the Handle bar:

1. Remove the plastic cover on the end of the handlebar stem by first removing the Velcro cover on top of the

handlebar stem and then loosening the chrome 12 mm bolt by 2-3 Turns to the left. The plastic cover should

slide off.

1 2 3 4 5 6 7 Next › »

Summary of Glider

Page 1
Ezee glider manual congratulations on your purchase of the ezee glider! Your glider is designed for years of nearly carefree use by your child. These instructions include how to set up your glider and the maintenance procedures which you should perform to ensure long-lasting use and optimal performa...
Page 2
2. Once the bolt is loose and the cover has been removed, insert the handlebars. Twist the handlebars so that it is perpendicular to the frame. 3. Tighten 12 mm bolt with provided wrench on top of stem until front wheel and handlebars won’t twist. 4. To adjust the angle of the handlebars for smaller...
Page 3
Installing and adjusting seat the proper seat height is achieved when your child can put both feet on the ground at the same time when seated. If the seat is too high or too low, use the quick-release to loosen the seat clamp bolt, adjust the seat to the proper height, and retighten quick release. T...
Page 4
Insert the wheel into the fork and replace the hook washers onto the axle so the tab fits into the corresponding hole, then put on flat washer and tighten the axle nuts with the provided tool. Brake handle adjustment the brake handle comes attached by the factory but you can adjust it for ease of us...
Page 5
Should spin freely but stop when lever is squeezed. When the bike is new there is a break-in period, wait until the bike has been used for a couple of hours then try to adjust it again. If the brake is too tight after you have turned the barrel adjuster clockwise all the way in or too loose after ad...
Page 6
Adjusting the foot pegs the foot pegs can be rotated either perpendicular to the bike so that the rider can use them to rest their feet or rotated in to keep them completely out of the way. To adjust the pegs, simply depress silver button on spring pin and turn until tab falls into the appropriate h...
Page 7
The glider is considered a sidewalk bike. As such, it does not meet the full requirements of a bicycle (height, reflectors, and brakes) and therefore should never be ridden on a road, street, or anywhere where cars may be traveling. It is designed for small kids to be ridden on sidewalks only and al...
Page 8
Performing stunts off-road riding any abnormal riding maintenance before riding: check your bike make sure your wheels are straight check tire inflation on models with air tires check brakes check attachment of both wheels check handlebars and stem for signs of stress or failure and that they are ti...