EZee Life 190 Tilt Shower Commode User Manual - page 4
6. The adjustment is made by simply
depressing the anti-tipper push pin (1),
sliding the inner
anti-tipper tube (2) to the desired length,
aligning the push pin with the closest
adjustment hole (3) and allowing it to pop
through.
(The anti-tippers should be as close to the
floor as possible without catching on
doorway thresholds, changes in floor levels or other obstacles.)
7. To attach the foot rest (1) to the commode
lower the foot rest pivot plug (2) into the
top of the
front seat frame (3) with the foot plate (4)
off to the side of the commode. Then
swing the foot
rest to the forward position where it will
lock in place.
8. The foot plate height can be adjusted by
loosening the footrest clamp (1), sliding
the the foot plate extension tube (2) up or
down inside the foot rest hanger tube (3)
and re-tightening the clamp.
DO NOT extend the footplates past the MAX line (4) stamped into
the foot plate extension tubes. The MAX line should not be visible.
9. From the back of the commode slide the commode
pail into the pail support channels (1) located on
the bottom of the seat pan (2).
10. Install the adjustable head rest (1) by inserting and
vertical support tube (2) into the headrest bracket
(3) mounted on the commode push bar and then
insert the horizontal support tube (4) through the
end bracket (5) of the vertical tube (2).
4