EZee Life CH3014 Instruction Manual - Handle Height Adjustment
Handle Height Adjustment
The rollator push handle s are adjustable height for comfort
and ease of use.
Depress the push pin,
Adjust the handle to the desired height
Allow the push pin to protrude back through the
closest adjustment hole.
Warning:
Ensure the push pin fully pops through the
frame adjustment hole.
Walker Handle Adjustment Guide
When the handle height of the walker is adjusted properly, the user can stand
with a normal posture while wearing the footwear they most commonly wear.
Adjusting the rollator walker height is easily done without the need of tools.
There will be a knob where the handles meet the frame of the walker which
when loosened and removed will allow the handles to be raised and lowered.
The seat height of the rollator walker will usually be fixed at a certain height
and not adjustable.
While the user is standing with their arms hanging limply at their sides, the
distance from the inside of their wrist (where a snug watchband would
normally be) to the floor should be equal to the top of the walker handles to
the floor.
Brake Operation & Adjustment
1. Pull up on brake handle lever to slow the rollator
2. Push down on brake handle lever to lock the rear wheels. Pull up on the
brake lever handle to release the lock
3. Brakes must be in the lock position when seat is going to be used. Ensure
the brakes are locked by pushing the rollator.
4. Brake adjustment Is carried out as following:
Turn the adjuster screw anti-clockwise to increase the
tension then lock the adjustment by turning the
Locking Nut clockwise while holding the adjustment
screw stationary stationary.
Bake adjustment reduced to allow use with too
light a pressure may be ineffective in locking the
brakes and preventing the rollator's movement.
5