F&U FL-16101 Instruction Manual - Product Introduction

Product Introduction

Install the TV Base

3. Warnings.

1. The parts 

needed for installing the stand (supplied)

TV set

Stand

Screws(supplied)

4 x ST3 x 10F

2. How to install the Stand?

Back

Front

Before installing the stand, please check that 

you have all of the parts and that there is no 

visible damage. If a part is missing or appears 

damaged, please contact customer service.

Put the Stand to the neck of the TV set as shown below, Please pay close attention to the plunger and slots.

1. Before you put on the stand, please make sure the direction is correct 

    as shown below.

2. When you are putting on the stand, please make sure the neck of the 

    TV set is in the correct position and attached tightly.

If you do not attach the stand correctly, it will make the TV unstable 

and may tip over.

Place the TV face down on a soft and flat surface (blanket, foam, cloth, etc.) to prevent any damage to the TV.

Attach the stand with the supplied screws.

When attaching the stand, make sure the screws 

are attached tightly.

If the screws do not attach tightly, it will lead the TV 

to be unstable or may even tip over.

b. It can not be tilted to the right or left as shown below.  

    Doing so may damage the stand.

a. It can not be tilted to the front or back as  

    shown below.  Doing so may damage the 

    stand.