F&V F3 Manual - page 8
常见问题排除
1. 只有黑白图像
A、请确认彩色级别的饱和度、亮度和对比度的调整是否合适
B、按面板上的“COLOR”键将彩色图像开起
2. 接上电源开启后无图像或无声音,屏幕显示无信号
A、查看AV、HDMI或SDI信号输入和输出端接触是否良好,确保使用标准的信号线
连接到监视器
B、无声音时,菜单中的声音功能模式,查看“静音”项是否关闭
3. 画面图像色彩失真或者是不正常的颜色,如缺少某种颜色:
请检查信号连接线是否连接正确.连接线的损坏或松动会造成信号的传输不良而引起
以上故障
-13-
-14-
1. The unit displays without color.
A
、Make sure that the color level settings are properly set for saturation, brightness and
contrast.
B
、Select the “Exit” key to switch between Color/B&W selection modes.
2. No image displayed after connecting to power.
A
、Make sure the Power ON/OFF key is depressed to the “ON” position.
B
、Make sure battery is fully charged and that the cables are properly connected.
3. Image on screen is distorted
A
、Select the same aspect ratio for the monitor (16:9 or 4:3) as set by your camera.
B
、Make sure cables are securely connected.Broken or loose cables can produce bad
signals which can effect the images on screen.
Troubleshooting