Fabco Power BD - 400SV Instruction Manual - On The Generator.
of
8
Fabco Power
Instruction Manual
• Page 3 •
Initial Installation and Start-Up
Be sure you set the speed of the generator at approximately
62.5 HZ or 3750 RPM with NO electrical load
on the generator.
By using this setting you will have approximately 60HZ
(cycles) or 3600 RPM when you are running at full rated load.
One way this can be accomplished is by using a Photo
Tachometer on our generator shaft.
A Photo Tachometer is an inexpensive tool that can be
purchased at McMasters, Grainger, Sears or any other electrical