Setting the standard in mobile power instruction manual for model hydro 800ep11 hydraulic generator manufacturing of: vehicle mounted generators • hydraulic generators po box 582, chester ny, phone: 845-469-9151, fax: 845-469-7871 web: www.Fabcopower.Com e-mail: mail@fabcopower.Com.
Fabco power instruction manual • page 2 • general information model: hydro 800ep-11 generator ............ Brushless generator ............ 3600 (60 hz) generator voltage ............ 120 or 120/240 motor starting ............ 300% surge voltage regulator ............ Inherent output ............ 80...
Fabco power instruction manual • page 3 • recommendations model: hydro 800ep-11 high pressure line ........................ ¾ inch low pressure line .......................... 1 inch flow rate .......................................... 12 to 60 gpm (12 gpm ideal) for best results keep hydraulic oil ...
Fabco power instruction manual • page 4 • initial installation and start-up be sure you set the hydraulic flow (gpm) to the generator at approximately 62.5 hz or 3750 rpm with no electrical load on the generator. By using this setting you will have approximately 60hz (cycles) or 3600 rpm when you ar...
Fabco power instruction manual • page 5 • technical information these self-excited and self-regulating generators, although overall dimensions have been reduced to a minimum, are designed for high-level electrical performance and the maximum in operating reliability. Preliminary checks: before touch...
Fabco power instruction manual • page 6 • electrical connections u2 v2 120 120 120 / 240 volt operation v1 w1 240 terminal block u2 v2 120 volt full power operation v1 w1 120 terminal block.
Fabco power instruction manual • page 7 • parts breakdown hydro 8 00 ep-11 no. Part # description 1 572416 louvered panel 2 572419 frame for stator 3 572420 drive end bell 3 a 572428 screen 4 572423 front bearing 5 572422 fan 6 572421 rotor 8 572424 rear bearing 13 572418 user terminal board 15 5724...
Fabco power instruction manual • page 8 • trouble shooting problems causes remedies alternator excitation failure 1. Low speed 2. Faulty capacitor 3. Faulty winding 1. Check rpm and set at nominal value. 2. Check and replace. 3. Check that winding resistance is as shown in the tables. High no-load v...
Fabco power instruction manual • page 9 • fixed displacement type gear pump 5 6 4 7 3 2 1 typical hydraulic schematic 8 1. Hydraulic pump 2. Pressure relief valve 3. Control valve 4. Priority flow control* 5. Generator hyraulic motor 6. Case drain line** 9 7. Return line filter 8. Oil cooler 9. Hydr...
Fabco power instruction manual • page 10 • brushless generator wiring.
Fabco power instruction manual • page 11 • fabco by-pass flow control fabco pn 572233 note: this assembly only needed with fixed displacement type gear pump..
Fabco power instruction manual • page 12 •.
Fabco power instruction manual • page 13 • top rear view case drain return pressure 11 cc piston motor all fittings are # 12 sae fabco power instruction manual note: the pressure and return ports can be used on the top or the rear of the motor by exchanging the 12 sae capped plug fittings. Shaft.
