Faber 5x20 5A Installation Instructions Manual - page 7
Version 01/05 - Page 7
Rangehood Control Panel
The control panel is located on the right-hand side under the
canopy. The position and function of each control button are
indicated in
FIGURE 13
.
Light On/Off Button ( L )
On/Off switch for the halogen lights. Move the switch to
"1" to turn the light ON and to "0" to turn it OFF.
Blower On/Off Button ( M )
On/Off switch for the blower. Move the switch to "1" to turn
the blower ON and to "0" to turn it OFF.
Blower Speed Button ( V )
Speed control for blower. Move the switch to position 1 for
LOW Speed, 2 for MEDIUM speed and 3 for HIGH speed.
For Best Results
Start the rangehood several minutes before cooking to
develop proper airflow. Allow the unit to operate for several
minutes after cooking is complete to clear all smoke and
odors from the kitchen.
Cleaning
The stainless steel grease filters should be cleaned frequently
in hot detergent solution or washed in the dishwasher. Clean
exterior surfaces with a commercially available stainless
steel cleaner. Abrasives and scouring agents can scratch
stainless steel finishes and should not be used to clean
finished surfaces.
Replacing the Halogen Lamps
Before you begin, make sure that the rangehood is turned off and
that the other lamps have had sufficient time to cool. Halogen bulbs
burn extremely hot and serious injury could result from touching a
hot bulb. To replace the lamp, the bezel (A) around the lamp(C)
must be removed as indicated in
FIGURE 14
. This bezel (A) is
held in place by two screws (B). Remove the two screws and the
bezel. Then remove the lamp and replace with a new lamp. Once
the new lamp is in place, reinstall the bezel.
• This rangehood uses 20 watt halogen lamps.
WARRANTY & SERVICE
All Faber products are warranteed against any defect in materials
or workmanship for the original purchaser for a period of 1 year
from the date of original purchase. This warranty covers labor
and replacement parts. The warranty does not cover consumable
parts such as filters and light bulbs. This warranty does not apply
if this product has been subjected to faulty installation, misuse, or
neglect. This warranty excludes any consequential expense or
damage resulting from any use or malfunction of the product. All
implied warranties are limited to the duration of this warranty.
To obtain warranty service, contact the dealer from whom you
purchased the rangehood, or the local Faber distributor. If you
cannot identify a local Faber distributor, contact us at (508) 358-
5353 for the name of a distributor in your area.
WIRING DIAGRAM
FIGURE 13
FIGURE 14
0 1
0 1
0 1 2
L
M
V
USE AND CARE INFORMATION
This rangehood system is designed to remove smoke, cooking
vapors and odors from the cooktop area.
For Best Results
Start the rangehood several minutes before cooking to develop
proper airflow. Allow the unit to operate for several minutes
after cooking is complete to clear all smoke and odors from the
kitchen.
FUSE REPLACEMENT
Fuse model 5x20 5A time-delay
1. Remove the filters
2. Remove the screws fixing the fuseholder box
3. Open the fuseholder (bayonet fixing)
4. Replace the fuse with another of the same type
5. Replace the fuseholder box and filters