Installation and operating instructions electrical ambience heating 40 010 464 99 49 varda/narvik ivar alma othello.
1 en en table of contents 1. Foreword 2 2. Introduction 3 3. Safety precautions 4 4. Installation 6 4.1 installation instructions 6 4.2 installation space 6 4.3 location and minimum free space 6 5. Operation 7 5.1 operation 7 5.2 flame effect 8 5.3 heating unit 8 5.4 thermostat operation 9 5.5 therm...
3 en 2 en en 2. Introduction this instruction manual gives you information about the design, operation and maintenance of your fire, as well as safety precautions and environmental recommendations. As you read this manual, you will quickly learn how to operate your fire. You will also find informati...
5 en 4 en - do not leave young children unsupervised in the vicinity of the heater. - do not use this heater in series with a thermal control, a programme controller, a timer or any other device that switches or the heater automatically, since a fire risk exists when the heater is accidentally cover...
7 en 6 en 5. Operation important: remove the cardbord liner the cardboard liner secured the fuel effect in place while the product was transported and should be removed after installation. Retain the cardboard liner, this must be refitted in the event of transporting the appliance. Follow the follow...
9 en 8 en 5.4 thermostat operation the thermostat controls the heat output according to the room temperature. This ensures that the heater will not produce heat unnecessary when the room is warm. Ivar/alma to set the temperature you require, turn the thermostat knob fully clockwise to 'max' position...
11 en 10 en ivar/othello to gain access to the lamps open the firebox door. Remove the two screws securing the fuel effect. Remove the fuel assembly by lifting the logs slightly and sliding out unscrew the defective lamp anti-clockwise. Replace with a 230 v, 40 w e14 ses lamp, do not over tighten. R...
