- DL manuals
- Faber
- Ventilation Hood
- ARKEA
- Instruction Manual
Faber ARKEA Instruction Manual
Summary of ARKEA
Page 1
Instructions manual manuel d’instructions bedienungsanleitung manual de instrucciones ǽȗȥıțȢȔİțȡ ȡİșȗțȬȟ ɋɮɥɩɝɩɟɬɭɝɩ ɪɩ ɸɥɬɪɦɮɛɭɛɱɣɣ gebruiksaanwijzing kullanim kilavuzu.
Page 2: Index
2 2 index recommendations and suggestions ..................................................................................................................... 4 characteristics .............................................................................................................................
Page 3: Inhoudsopgave
3 3 inhoudsopgave adviezen en suggesties........................................................................................................................................... 100 eigenschappen .........................................................................................................
Page 4: Installation
En 4 4 recommendations and suggestions the instructions for use apply to several versions of this appliance. Accordingly, you may find descriptions of individual features that do not apply to your specific appliance. Installation • the manufacturer will not be held liable for any damages resulting f...
Page 5: Use
En 5 5 • if the instructions for installation for the gas hob specify a greater distance specified above, this has to be taken into account. Regulations concerning the discharge of air have to be fulfilled. • use only screws and small parts in support of the hood. Warning: failure to install the scr...
Page 6: Maintenance
En 6 6 • “caution: accessible parts may become hot when used with cooking appliances.” maintenance • switch off or unplug the appliance from the mains supply before carrying out any maintenance work. • clean and/or replace the filters after the specified time period (fire hazard). • the grease filte...
Page 7: Characteristics
En 7 7 characteristics dimensions 600 5 1 6 5 6 0 m a x 1 3 0 0 400 components ref. Q.Ty product components 1 1 hood canopy complete with: controls, light, filters, motor. 2 1 hood support plate. Ref. Q.Ty installation components 11 4 wall plugs ø 10 12h 4 screws 4.2 x 44.4 q.Ty documentation 1 inst...
Page 8: Installation
En 8 8 installation this hood is designed to be mounted on the ceiling/on a shelf, above a free-standing hob (min. 650 mm), in: • recirculation version: internal recirculation. Sequence of operations - installation • preparing for installation • drilling the ceiling/shelf and fixing the support plat...
Page 9
En 9 9 ceiling/shelf drilling and plate fixing ceiling/shelf drilling • use a plumb-line and mark the centre of the cooking hob on the support ceiling/shelf • rest the plate against the ceiling/shelf, making sure it is the right way up, as shown in the figure. • mark the centres of the holes in the ...
Page 10
En 1 10 fixing the plate • lift up the fixing plate and fit the slots onto the two screws previously inserted in the ceiling, and turn un- til they are at the centre of the adjustment slot. Warning: the plate must be facing in the direction shown in the figure • tighten the two screws completely and...
Page 11
En 1 11 connecting hood-plate cables n.B. Before proceeding with installation the hood must be raised to a height of at least 650 mm above the cooker hob by means of a support or with the assistance of another person. Take care not to exceed the maximum hood extension indicated in the dimensional dr...
Page 12
En 1 12 • pay attention to the direction of the plate fixed to the ceiling (the plate limit pawl has a corresponding hole on the plate cover and on the hood canopy). • insert the safety knobs (c) into the respective cables, with the thread to the top. • insert the cable locking screws (b) into the r...
Page 13
En 1 13 • pass the cables into the slots on the threaded pawls (a) and tighten the cable locking screws (b) into the pawls themselves. • when the operation has been completed, the result should be as shown in the figure for all 4 cables. • at this point, all 4 cables are now connected to the plate. ...
Page 14
En 1 14 fixing the power supply cable • tighten the power supply cable and fix it to the bracket on the ceiling- mounted plate, using the tongue already mounted and 2 screws. • slot the rubber cable raceway already threaded onto the power cable into the slot to prevent future damage. • connect the h...
Page 15: Use
En 1 15 use control panel l t1 button function display l turns the lights on/off. - t1 hood down press for 2 seconds to raise the hood. Press briefly to turn the motor on/off. On/off hood up press once: the hood lowers. Press a second time: the hood stops. When the movement has been completed the mo...
Page 16
En 1 16 remote control the appliance can be controlled using a remote control powered by a 1.5 v carbon-zinc alkaline batteries of the standard lr03- aaa type (not included). • do not place the remote control near to heat sources. • used batteries must be disposed of in the proper manner. Control pa...
Page 17: Maintenance
En 1 17 maintenance grease filter the filter must be cleaned every 2 months of operation, or more frequently for particularly heavy usage, and can be washed in a dishwasher. Cleaning metal self- supporting grease filter • open the lighting unit by pulling on the nocth. • remove the filter one by one...
Page 18
En 1 18 additional information for the installation technician hood canopy lighting it is possible to adjust the colour and intensity of the hood canopy lighting • open the lighting unit by pulling on the notch provided. • adjust the lighting, using the buttons on button pad b, following the indicat...
Page 19
En 1 19 adjusting hood canopy lighting button colour function 1 red manages the intensity of the colour red. Press and hold the button to increase or decrease the intensity each time you press. The maximum and minimum intensity limits are marked by a brief flash of the selected colour on the lamp. 2...
Page 20: Conseils Et Suggestions
Fr 2 20 conseils et suggestions les instructions pour l’utilisation se réfèrent aux différents modèles de cet appareil. Par conséquent, certaines descriptions de caractéristiques particulières pourraient ne pas appartenir spécifiquement à cet appareil. Installation • en aucun cas le fabricant ne peu...