Instruction manual read and save these instructions the installer must leave these instructions with the homeowner. The homeowner must keep these instructions for future reference and for local electrical inspectors’ use. Concept remote blower.
2 en contents warning 3 characteristics 5 installation 8 use 13 maintenance 14.
3 en read these instructions before you start installing this rangehood read and save these instructions warning: - to reduce the risk of a range top grease fire: never leave surface units unattended at high settings. Boilovers cause smoking and greasy spillovers that may ignite. Heat oils slowly on...
4 en this appliance should be connected directly to the fused disconnect (or circuit breaker) through flexible, armored or nonmetallic sheathed copper cable. Allow some slack in the cable so the appliance can be moved if servicing is ever necessary. A ul listed, 1/2" conduit connector must be provid...
5 en 1 3 4 5 10 11 12 13 g e f d c a 2 characteristics components q.Ty 1 1 hood body, complete with: blower, filters, controls 2 1 built-in hood body case 3 1 rear remote motor connection panel 4 1 top air outlet flange with valve 5 1 top air outlet plug 10 1 light 11 4 support arms 12 2 bush maskin...
6 en dimensional chart - hood distance from the hob.
7 en dimensional chart - light.
8 en installation the hood can be installed in the following ways: top air outlet, bottom air outlet, rear air outlet. Once the desired configuration has been chosen (see the diagrams below) it will be necessary to provide an opening in the wall where to house the built-in hood body case. Besides th...
9 en lighting unit installation scheme lighting unit lower border shall be installed at the minimum distance of 34 9/16 in. Above the cooking surface. With the aid of the drilling template provided mark the necessary holes and drill them. ø15/16 top or bottom air outlet configuration the hood is man...
10 en rear air outlet configuration • remove the suction panel by unfastening the 8 screws around the frame. • remove the metal grease filters. • remove the metal profile fixed to the flange by unfastening the 5 screws. • fit the air outlet plug into the top air outlet. • remove the rear air outlet ...
11 en hood body installation • in case of the bottom air outlet configuration the hood body has to be turned 180°. • remove the top cover of the terminal box by unfastening the two screws fixing it to the hood casing. • with the aid of pliers brake through a hole inside the terminal box providing th...
12 en lighting unit installation • provide for passage of the electrical connection wires with the hood body. • slide the top cover downwards, unfastening the two side screws and taking care not to scratch the tubular support members. • insert the 4 plugs d into the earlier drilled holes. • decide t...
13 en electrical connection electrical shock hazard • disconnect power before making electrical connctions. • connect ground wire to green ground screw in terminal box. ! Warning green ground screw hood wiring purple wiring red wiring hood wiring black wiring white wiring power supply conduit light ...
14 en maintenance grease filters cleaning metal grease filters •alarm signal reset • switch off the lights and extractor motor. • press button t3 for at least 3 seconds, until the leds start to flash. Cleaning the filters • open the suction cover using the lever provided. • the filters are washable ...
15 en electric diagram lighting light replacement 20 w halogen light. • extract the lamp from the support. • replace with another of the same type, making sure that the two pins are properly inserted in the lamp holder socket holes..
436002499_02 - 041103.
