Faber FSH DUAL D100 VH Instruction Manual - Note

Page of 12

Download

Print this page

Bookmark us

NOTE

D represents the wall-mounted distance between holes of horizontal, E represents the

wall-mounted distance between holes of vertical.

3.1 Installation Instruction

①

②

3. UNIT INSTALLATION

2.4 Internal Wire Diagram

WIRING DIAGRAM FOR FSH DUAL D**VH

This electrical water heater shall be installed on a solid wall. If the strength of the wall cannot

bear the load equal to two times of the total weight of the heater filled fully with water, it is

then necessary to install a special support.

Incase of hollow bricks wall, ensure to fill it with cement concrete completely.

After selecting a proper location, determine the positions of the two install holes used for

expansion bolts with hook (determined according to the specification of the product you

select). Make two holes in the wall with the corresponding depth by using a chopping bit with

the size matching the expansion bolts attached with the machine, insert the screws, make

the hook upwards, tighten the nuts to fix firmly, and then hang the electric water heater on it

(see Fig.2).

Heating Element

Heating Indicator Light

Power Indicator Light

Thermal

Cut Out

Thermostat

ON/OFF

« ‹ Prev 3 4 5 6 7 8 9 Next › »

Summary of FSH DUAL D100 VH

Page 1
Storage electric water heater the diagram above is just for reference. Please take the appearance of the actual product as the standard. Instruction manual for model: fsh dual d30 vh fsh dual d50 vh fsh dual d80 vh fsh dual d100 vh thank you very much for purchasing our water heater. Before installi...
Page 2
1 the manufacturer shall not be held responsible for any damage or malfunction caused by wrong installation or failing to comply with following instructions included in this pamphlet. For more detailed installation and maintenance guidelines, please refer to below chapters. Table of contents title p...
Page 3
2 the supply socket must be earthed reliably. The rated current of the socket shall not be lower than 10a. The socket and plug shall be kept dry to prevent electrical leakage. Inspect frequently whether the plugs contact well with the socket. Inspect method is as follows: insert the power supply plu...
Page 4
3 2. Product introduction model rated voltage (acv) ipx4 ipx4 ipx4 ipx4 75 75 75 75 0.75 0.75 0.75 0.75 220-240 220-240 220-240 220-240 1500 1500 1500 1500 30 50 80 100 fsh dual d30 vh fsh dual d50 vh fsh dual d80 vh fsh dual d100 vh rated power (w) volume (l) rated pressure (mpa) max of water tempe...
Page 5
4 2.3 brief introduction of product structure product structure for vertical product structure for horizontal (note:all dimensions are in mm) a b c d e 340 593 262 193 fsh dual d30 vh 196 fsh dual d50 vh 385 711 296 310 196 fsh dual d80 vh 385 1030 296 612 196 fsh dual d100 vh 450 915 372 447 196 d ...
Page 6: Note
Note d represents the wall-mounted distance between holes of horizontal, e represents the wall-mounted distance between holes of vertical. 3.1 installation instruction ① ② 3. Unit installation 2.4 internal wire diagram 5 wiring diagram for fsh dual d**vh this electrical water heater shall be install...
Page 7
3.2 pipelines connection ③ ④ 6 product structure for vertical install the supply socket in the wall. The requirements for the socket are as follows:250v/10a, single phase, three electrodes. It is recommended to placed the socket on the right above the heater. The height of the socket to the ground s...
Page 8
If the users want to realize a multi-way supply system, refer to the method shown in fig.5 for connection of the pipelines. 7 ④ product structure for horizontal (fig.4) (fig.5) water inlet valve water inlet valve running water pipe mixing valve water pool triple joint shower nozzle hot water outlet ...
Page 9: Note
8 note please be sure to use the accessories provided by our company to install this electric water heater. This electric water heater can not be hung on the support until it has been confirmed to be firm and reliable. Otherwise, the electric water heater may drop off from the wall, resulting in dam...
Page 10: Warning
Check the power plug and outlet as often as possible. Secure electrical contact and also proper grounding must be provided. The plug and outlet must not heat excessively. If the heater is not used for a long time, especially in regions with low air temperature(below 0 ℃ ), it is nessary to drain wat...
Page 11: Note
6. Troubleshooting note parts illustrated in this use and care manual are indicative only, parts provided with the product may differ with illustrations.This product is intended for household use only. Specifications are subject to change without notice. 10 failures reasons treatment the heating ind...
Page 12
The product is subject to change without notice. Please keep this manual properly..