Faber FWH OTTIMO 501CH Instruction Manual - Warning

6

3.1 Installation Instruction

3.2 Power Cord Installation

Check the capacity of power circuit;

Power cord installation;

Water heater installation;

Plumbing connection;

Power supply connection;

①

②

③

④

⑤

Water Supply.

Step 1

Step 2

⑥

3. UNIT INSTALLATION

Step 3

Step 4

Step 5

Step 6

Remove the screws at the bottom of the unit. Lift 

up the Main Switch Knob and Power Knob  to 

make it free. Remove the front plate gently.

Gash the middle of the film of the power cord 

jacket with a sharp knife in order to put into 

power lines.

Tighten the wire-pressing plate with screws to 

primary position, ensure that the power cord not 

be pulled out more than 60N.

Remove the power cord wire pressing plate and 

keep the screws.

Screw the power cord into the jacket for 

installation of wire pressing plate.

Connect the power cord to wiring terminals; the 

method is as shown in picture.

WARNING

Minimum conductor sizes

Live: 4mm²    Neutral: 4mm²    PE: 4mm² 

!