Faber Matrix Installation Instructions Manual

Summary of Matrix

  • Page 1

    Version 04/08 - page 1 matrix wall mount luxury rangehood • installation instructions • use and care information read and save these instructions the installer must leave these instructions with the homeowner. The homeowner must keep these instructions for future reference and for local electrical i...

  • Page 2: Warning

    Version 04/08 - page 2 venting requirements determine which venting method is best for your application. Ductwork can extend either through the wall or the roof. The length of the ductwork and the number of elbows should be kept to a minimum to provide efficient performance. The size of the ductwork...

  • Page 3: Avertissement

    Version 04/08 - page 3 rÈglements d'Évacuation confirmer la sortie d'évacuation - soit par le mur, soit par le toit. Utilisez une longueur de tuyauterie minimale avec les moindres de coudes pour la plus grande efficacité. Le diamètre de tuyauterie doit être uniforme. N'installez jamais 2 coudes ense...

  • Page 4: Warning

    Version 04/08 - page 4 for best results, use no more than three 90° elbows. Make sure that there is a minimum of 24" of straight duct between elbows if more than one is used. Do not install two elbows together. If you must elbow right away, do it as far away from the hood's exhaust opening as possib...

  • Page 5

    Version 04/08 - page 5 ducted installation dimensions (vented to the outside) ductless installation dimensions (not vented to the outside).

  • Page 6

    Version 04/08 - page 6 prepare the wall 1. Disconnect and move freestanding range from cabinet open- ing to provide easier access to rear wall. Put a thick, protective covering over cooktop, set-in range or countertop to protect from damage or dirt. 2. Determine and clearly mark with a pencil the ce...

  • Page 7

    Version 04/08 - page 7 ducted installations figure 7 1. For rear ducted installations, attach the rear chimney transition to the top of the rangehood (figure 7) with the 4 screws provided. 2. If installing the hood with ductwork venting up thru the ceiling (not to the rear of the hood thru the wall ...

  • Page 8

    Version 04/08 - page 8 use and care continued - control panel the hood can be operated from the control panel located on the right hand side of the hood or from the remote control. The figure 12 is an illustration of the control panel. The hood can be turned on by pushing any speed button t1 thru t4...

  • Page 9

    Version 04/08 - page 9 use and care continued - maintenance charcoal filter information the charcoal filters should be replaced (as indicated in figure 9) when the s1 led light flashes or at least every 4 - 6 months depending on heavy usage. The alarm only comes on when the motor is turned on. To re...

  • Page 10

    Version 04/08 - page 10 faber warranty & service (save for your records) all faber products are warranteed against any defect in materials or workmanship for the original purchaser for a period of 1 year from the date of original purchase. This warranty covers labor and replacement parts. To obtain ...

  • Page 11: Avertissement

    Version 04/08 - page 11 pour de meilleurs résultats, ne pas utiliser plus de trois coudes de 90 o . S’assurer qu’il y ait un minimum de 24 po de conduit droit entre les coudes si l’on utilise plus d’un coude. Ne pas installer deux coudes ensemble. Figure 3 figure 2 plan de l’installation la hotte de...

  • Page 12

    Version 04/08 - page 12 dimensions d’installation avec conduit dimensions d’installation sans conduit.

  • Page 13

    Version 04/08 - page 13 prÉparation du mur 1. Débrancher et enlever la cuisinière afin d’avoir un meilleur accès au mur arrière. Placer un recouvrement épais sur la plaque de cuisson, la cuisinière encastrée ou le dessus du comptoir pour protéger des dommages et de la poussière. 2. Déterminer et mar...

  • Page 14

    Version 04/08 - page 14 installations avec conduit figure 7 1. Pour installation avec conduit arrière, reliez la transition arrière de la cheminée au dessus de la hotte de cuisinière (schéma 7), avec les 4 vis fournies. 2. Si la hotte est installée avec ventilation au plafond (et non à travers le mu...

  • Page 15

    Version 04/08 - page 15 panneau de contrÔle - utilisation et entretien (suite) la hotte peut être opérée directement du panneau de contrôle, situé du côté droit de la hotte, ou du contrôle à distance. Le schéma 12 illustre le panneau de contrôle. La hotte peut être mise en marche en poussant un bout...

  • Page 16

    Version 04/08 - page 16 entretien - utilisation et entretien (suite) informations sur le filtre À charbon les filtres à charbon doivent être replacés (tel qu’indiqué au schéma 9) lorsque la lumière led s1 clignote ou , au moins aux 4 ou 6 mois, selon l’utilisation. L’alarme ne se déclenche que lorsq...

  • Page 17

    Version 04/08 - page 17 faber garantie et service ( Économiser pour vos enregistrements ) faber garantit à l’utilisateur-acheteur d’origine que les produits faber vendus neufs par nous sont sans vice de matériel et de main-d’oeuvre d’origine pour une période d’un an à partir de la date d’achat. La g...