Faber MIRROR Installation Instructions Manual

Manual is about: Wall Mount Luxury Rangehood

Summary of MIRROR

  • Page 1

    Version 8/10 - page 1 mirror wall mount luxury rangehood • installation instructions • use and care information read and save these instructions the installer must leave these instructions with the homeowner. The homeowner must keep these instructions for future reference and for local electrical in...

  • Page 2: Warning

    Version 8/10 - page 2 venting requirements determine which venting method is best for your application. Ductwork can extend either through the wall or the roof. The length of the ductwork and the number of elbows should be kept to a minimum to provide efficient performance. The size of the ductwork ...

  • Page 3: Avertissement

    Version 8/10 - page 3 rÈglements d'Évacuation confirmer la sortie d'évacuation - soit par le mur, soit par le toit. Utilisez une longueur de tuyauterie minimale avec les moindres de coudes pour la plus grande efficacité. Le diamètre de tuyauterie doit être uniforme. N'installez jamais 2 coudes ensem...

  • Page 4: Warning

    Version 8/10 - page 4 for best results, use no more than three 90° elbows. Make sure that there is a minimum of 24" of straight duct between elbows if more than one is used. Do not install two elbows together. If you must elbow right away, do it as far away from the hood's exhaust opening as possibl...

  • Page 5

    Version 8/10 - page 5 installation dimensions front side view product dimensions (with rear venting chimney).

  • Page 6

    Version 8/10 - page 6 prepare the wall 1. Disconnect and move freestanding range from cabinet opening to provide easier access to rear wall. Put a thick, protective covering over cooktop, set-in range or countertop to protect from damage or dirt. 2. Determine and clearly mark with a pencil the cente...

  • Page 7

    Version 8/10 - page 7 ducted installations figure 7 1. For rear ducted installations, attach the rear chimney transition to the top of the rangehood (figure 7) with the 4 screws provided. 2. If installing the hood with ductwork venting up thru the ceiling (not to the rear of the hood thru the wall )...

  • Page 8

    Version 8/10 - page 8 use and care continued - control panel the hood can be operated from the control panel located in the center of the hood , figure 10 is a picture of the control panel, with led display in the center key a b c d e f g h i l function door closed: press and hold for 2 seconds to o...

  • Page 9

    Version 8/10 - page 9 use and care continued - maintenance replacing the lamps remove the lights from the housing and replace the lamp with a 20 w mr-11 halogen lamp. Make sure that the two pins are properly inserted into the lamp holder socket. Replace the light cover. An alternative method to repl...

  • Page 10

    Version 8/10 - page 10 use and care continued - maintenance replacing the fuse the upper hood panel opening and closing is controlled by a gear motor supplied by a circuit with a fuse. If this fuse blows and the panel is closed, then the panel must be manually pulled out for fuse replacement. Follow...

  • Page 11

    Version 8/10 - page 11 faber warranty & service (save for your records) all faber products are warranteed against any defect in materials or workmanship for the original purchaser for a period of 1 year from the date of original purchase. This warranty covers labor and replacement parts. To obtain w...

  • Page 12: Avertissement

    Version 8/10 - page 12 pour de meilleurs résultats, ne pas utiliser plus de trois coudes de 90 o . S’assurer qu’il y ait un minimum de 24 po de conduit droit entre les coudes si l’on utilise plus d’un coude. Ne pas installer deux coudes ensemble. Figure 3 figure 2 plan de l’installation la hotte de ...

  • Page 13

    Version 8/10 - page 13 dimensions d'installation avant vue de cÔtÉ dimensions de produit (avec la cheminée arrière de mise à l'air libre).

  • Page 14

    Version 8/10 - page 14 prepare the wall 1. Débrancher et enlever la cuisinière afin d’avoir un meilleur accès au mur arrière. Placer un recouvrement épais sur la plaque de cuisson, la cuisinière encastrée ou le dessus du comptoir pour protéger des dommages et de la poussière. 2. Déterminer et marque...

  • Page 15

    Version 8/10 - page 15 ducted installations figure 7 1. Pour installation avec conduit arrière, reliez la transition arrière de la cheminée au dessus de la hotte de cuisinière (schéma 7), avec les 4 vis fournies. 2. Si la hotte est installée avec ventilation au plafond (et non à travers le mur arriè...

  • Page 16

    Version 8/10 - page 16 soin d'utiliser-et continu - panneau de commande le capot peut être actionné à partir du panneau de commande situé dans le centre du capot, le schÉma 10 est une image du panneau de commande, avec l'affichage à led au centre clef a b c d e f g h i l fonctions porte fermée : app...

  • Page 17

    Version 8/10 - page 17 figure 12 soin d'utiliser-et continu - maintenance substitution des lampes retirez la couverture légère en retirantles vis sur le guide optique. Enlevez les lumières du logement et remplacez la lampe par 20 une lampe d'halogène de w, mr-11. Assurez- vous que les deux broches s...

  • Page 18

    Version 8/10 - page 18 soin d'utiliser-et continu - maintenance substitution du fusible l'ouverture et la fermeture supérieures de panneau de capot est contrôlée par un moteur de vitesse alimenté par un circuit avec un fusible. Si ce fusible souffle et le panneau est fermé, alors le panneau doit êtr...

  • Page 19

    Version 8/10 - page 19 faber garantie et service ( Économiser pour vos enregistrements ) faber garantit à l’utilisateur-acheteur d’origine que les produits faber vendus neufs par nous sont sans vice de matériel et de main-d’oeuvre d’origine pour une période d’un an à partir de la date d’achat. La ga...